VIDEX 2313 Remote Relay for VX2300 system User Manual

DIMANSION PRODUCT

DESCRIPTION

Remote relay for VX2300 system.
All entrance panels on the VX2300 system include the lock release relay and push to exit button input inside the entrance panel. For higher security applications including installations in compliance with ‘Secured By Design’ the 2313 enables the relay and push to exit button input 1 to be installed in a secure location away from the entrance. There is also a second relay that can be activate pressing the service button present in every VX2300 phone or videophone.

LEGEND
A Connection terminals covers
B Dip-switch cover
C Connection terminals
D 8 way dip-switch

1. Remove the terminal side covers by unscrewing the retaining screws (Fig. 3).
   
2. Fix the device to a DIN rail (Fig. 4) or directly to the wall using two expansion type screws (Fig. 5).
   
   
3. Isolate the mains using the circuit breaker mentioned above then make the connections as shown on the installation diagrams (if provided).
4. Check all connections and secure the wires into the terminals;
5. When all connections are made replace and fix the terminal covers with the relevant screws (Fig. 6).
   
6. Restore the mains.
7. Programming is made by dip-switch D accessible by lifting up the cover B (Fig. 7).
   
   

PROGRAMMING RELATED TO OUTDOOR STATION ADDRESS

Switch	Nr.1	Nr.2	Nr.3	Nr.4	ID
	OFF	OFF	OFF	OFF	1
	ON	OFF	OFF	OFF	2
	OFF	ON	OFF	OFF	3
	ON	ON	OFF	OFF	4
	OFF	OFF	ON	OFF	5
	ON	OFF	ON	OFF	6
	OFF	ON	ON	OFF	7
	ON	ON	ON	OFF	8
	OFF	OFF	OFF	ON	9
	ON	OFF	OFF	ON	10
	OFF	ON	OFF	ON	11
	ON	OFF	ON	ON	12
	OFF	OFF	ON	ON	13
	ON	OFF	ON	ON	14
	OFF	ON	ON	ON	15

RELAY 1 TIME
PTE teminal open Relay 1 for the setted time.

Switch	Nr.5	Nr.6	Setting Up
	OFF	OFF	= 2 seconds
	OFF	ON	= 8 seconds
	ON	OFF	= 16 seconds
	ON	ON	= 32 seconds

CONNECTION TERMINALS

To access to the connection terminals, first remove both the retaining screws, then the covers A (Fig. 8).

GND	Ground
BUS1	BUS Input/Output
BUS2	BUS Input/Output

PTE	Open relay 1 for the setted time	Max 24Vac/dc 5A
NC1	Relay 1 normally closed contact
NO1	Relay 1 normally open contact
CO1	Relay 1 common contact
NC2	Relay 2 normally closed contact
NO2	Relay 2 normally open contact
CO2	Relay 2 common contact

TECHNICAL SPECIFICATIONS

Housing/Mounting: 5 module A type DIN box DIN bar or directly to the wall
Dry contacts relay: Max 24Vac/dc 5A
Power supply: Supplied by the BUS line
Working temperature: -20 +60°C

Documents / Resources

VIDEX 2313 Remote Relay for VX2300 system [pdf] User Manual 2313 Remote Relay for VX2300 system, 2313, Remote Relay for VX2300 system, Relay for VX2300 system

References

• User Manual