Waterdrop X Series Reverse Osmosis System User Guide

X Series Reverse Osmosis System

Product Specifications

  • Product Name: X Series Reverse Osmosis Water Filtration
    System
  • Models Available: WD-X8, WD-X8-WAN, WD-X10, WD-X10-WAN
  • Certifications: IAPMO R&T certified against NSF/ANSI
    Standard 42&58 for reduction of specified claims, and NSF/ANSI
    372 for low lead

Product Usage Instructions

Installation

  1. Locate a suitable place for the system near a water source and
    drainage.
  2. Follow the installation manual provided with the product to
    connect the system to your water supply.
  3. Ensure all connections are secure before turning on the water
    supply.

Filter Replacement

  1. Regularly check the filter status indicator on the system.
  2. Refer to the user manual for guidance on how to replace filters
    when needed.
  3. Make sure to use only compatible replacement filters
    recommended by the manufacturer.

Maintenance

  1. Flush the system according to the maintenance schedule provided
    in the manual.
  2. Clean any external parts of the system with a damp cloth
    regularly.
  3. Contact technical support for any maintenance or operational
    issues.

FAQ

Q: How often should I replace the filters?

A: Filter replacement frequency can vary based on usage and
water quality. It is recommended to follow the guidelines in the
user manual for optimal performance.

Q: Is professional installation required?

A: While professional installation is not mandatory, it is
recommended for ensuring proper setup and functionality of the
system.

Q: What should I do if there is a leak in the system?

A: Turn off the water supply immediately and check all
connections. Tighten any loose fittings and contact technical
support if the issue persists.

“`

X Series Reverse Osmosis Water Filtration System
MODEL: WD-X8/WD-X8-WAN/WD-X10/WD-X10-WAN

System Certified by IAPMO R&T against NSF/ANSI Standard 42&58 for the reduction of the claims specified on the Performance Data Sheet, and to NSF/ANSI 372 for low lead.

Performance Data Sheet

Model WD-X8/WD-X8-WAN WD-X10/WD-X10-WAN WD-X8/WD-X8-WAN
WD-X10/WD-X10-WAN

Substance
TDS
TDS
Chlorine Taste and Odor Chlorine Taste and Odor

NSF Specified challenge concentration
750±40 mg/L 750±40 mg/L
2.0±0.2 mg/L
2.0±0.2 mg/L

Max permissible product water concentration
187 mg/L 187 mg/L
/
/

NSF reduction requirements
75% 75%
50%
50%

test result 96.79% 94.38% 98.82%
98.82%

This system has been tested according to NSF/ANSI 42&58 for reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42&58.

Manufacturer Technical Support
Tel: 1-888-352-3558 (U.S.) E-mail: service@waterdropfilter.com

Made in China P001 Qingdao Ecopure Filter Co., Ltd.

Documents / Resources

Waterdrop X Series Reverse Osmosis System [pdf] User Guide
WD-X8, WD-X8-WAN, WD-X10, WD-X10-WAN, X Series Reverse Osmosis System, X Series, Reverse Osmosis System, Osmosis System, System

References

Leave a comment

Your email address will not be published. Required fields are marked *