Wallystech AP Controller
User Manual
Wallystech AP Controller
Hardware-Based Wired and Wireless Device Network Controller
Section Ⅰ Getting Started
This section provides an overview of the Wallys AP Controller software and describes the initial steps required to start using the service.
Chapter 1 | Introduction
Wallys AP Controller Login
The Wallys AP Controller is a hardware-based network solution tailored for efficiently configuring multiple access points through a web browser interface. With its robust scalability, it supports the management of unlimited networks and devices.
By integrating network management and wireless controller functionalities, it allows Wallystech access points (APs) to seamlessly connect and operate as a unified network.
The following devices are supported by Wallys AP Controller:
Wallys APs: DR5018,DR5018S,DR6018,DR6018S,DR6018C
Wallys AP Controller Login
From a web browser, go to 192.168.1.1 to login.
Default User Name: admin
Default Password: 123456
Capture APs
Adding Devices(Capture APs)
Device Management View
Adding Devices
Adding Devices Warning Message
Adding Devices Successful Message
Firmware Upgrade & Filtering
Firmware Upgrade Button
Filtering the Device View
Change Default Password
Change Default Password Successful
After New Password Applied,the webpage will auto turn to Home page.
Change Default AP Controller IP Address
Change Default IP Address Successful
After New IP address Applied,the webpage will auto turn to Home page.
Set Up Multiple IP Addresses Across Different Network Segments
Function Diagram
Set Up Multiple IP Address Successful
System Upgrade
User Manage
Section Ⅱ Configuration
This section provides details on configuring access point settings.
The Dashboard
The dashboard provides an overview of status for configured devices, recent activity information overview.
Monitor
Configure WiFi in Batch
Configure WiFi
Upgrading Device Firmware
Viewing Device Information
Click a device name link in the Name column to access the detailed deviceinformation.
Upgrading Device Firmware
Click the upgrade icon in the FW column when new firmware is available for a device.
Note: check√ the box “save configuration”if need to keep the configuration remain.
New FW Upgrading process
Upgrading Device Firmware Successful
Active: running-upgrading-flashing-upgrade success-running
Deleting Offline Devices
Deleting Offline Devices Successful
Update Equipment Notes
Equipment Notes for Group Management
Importing Witelist
Witelist upload for your AP Devices
Execute Command
Input Command(eg.as picture below)
Documents / Resources
 |
Wallystech Wallys AP Controller Software [pdf] User Guide DR5018, DR5018S, DR6018, DR6018S, DR6018C, Wallys AP Controller Software, AP Controller Software, Software |