Walker Filtration T Series Filtration Pump With Timer Owner’s Manual

The T series is equipped with an autonomous timer integrated into the terminal box. The basic cycle is 24 hours (i.e. one day) in which an operating range of 2H, 4H, 6H, 6H, 6H, 8H, 8H, 10H, 12H, 14H, 16H or 24H can be set
Example: The timer will start every day at the time you made the setting. At 8:00 am, you choose the 2H range, the pump will run for 2 hours, i.e. until 10:00 am then the water pump will stop until 8:00 am and so on until you have made a new setting.
The timer is self-powered by a battery. In the event of a power failure, the settings are stored in memory
Example: In the event of a power failure between 9:00 a.m. and 12:00 p.m., the pump will run properly from 8:00 a.m. to 10:00 a.m. the next morning.

Pump diagram:

1. Bouchon vidange
2. Body cover
3. Pump body
4. Filter
5. Timer box
6. Fan cover
   

Settings:
Example for a duration of 6 hours.

1. Turn on the power.
   
2. Press on TIMER button, until the indication light 6 being red.
   
3. Press ON/OFF button to start the pump, then the 6 hours timing starts.
   
4. First, press ON/OFF button, make the pump at waiting state.
   
5. Then, press TIMER button until the indication light 16H turning bright.
   
6. Then press ON/OFF to start the water pump, the 16 delay is used for the next cycles.
   

Installing or replacing the battery:

Attention / Caution.

DISCONNECT THE PUMP FROM THE ELECTRICAL NETWORK BEFORE REPLACING THE BATTER.

use “Y” screw driver to remove the four screws on the cover.

take away the cover.

carefully remove the existing battery

put the button battery at the right position carefully!

Put the cover back to the original place.

Use a screwdriver to replace the screws.

Documents / Resources

Walker Filtration T Series Filtration Pump With Timer [pdf] Owner's Manual 100517T, 100518T, T Series Filtration Pump With Timer, T Series, Filtration Pump With Timer, Pump With Timer, Timer

References

• User Manual