VEVOR SX-001 Pointer Clock
Specifications
- Model: SX-001
- Product: POINTER CLOCK
- Manufacturer: Shanghaimuxinmuyeyouxiangongsi
Product Usage Instructions
Time Setting Instructions
- Install an AA battery (not included) into the battery compartment as shown in the diagram above. First insert the positive pole, then insert the negative pole.
- Rotate the time setting knob to set the desired time.
- When replacing the battery, first remove the positive electrode, followed by the negative electrode.
INTRODUCTION
- Read this material before using this product.
- Failure to do so can result in serious injury.
SAVE THIS MANUAL
- Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance, and cleaning procedures.
- Write the month and year of purchase. Keep this manual and the receipt in a safe and dry place for future reference.
UNDERSTAND YOUR TOOL
TIME SETTING INSTRUCTIONS
- Install an “AA” battery (not included) into the battery compartment as shown in the diagram above. First insert the positive pole, then insert the negative pole.
- Rotate the time setting knowledge to set the time you need.
- When replacing the battery, it is also necessary to first remove the positive electrode, followed by the negative electrode.
Instructions
- What could I do if the clocks don’t work or the clock hands are loose?
- Please follow the instructions to check and install.
- Insert the battery in the correct position according to (+) and (-), making in the battery compartment. The clock will not work if you put it by contrary.
- Note: A carbon-zinc battery is the best to make sure its long time using.
- Make sure the two clock hands are parallel on the clock face. If the clock’s hands are a bit bent or overlapping, please make them flat again and re-install both.
- During shipping, the clock’s hands may be a bit loose or droop, which may affect the clockwork. Don’t worry, it is not a quality problem, just need you to remove all the parts as we showed, and re-install it to make everything perfect.
- If the clock still can’t work, please turn the brass nut several times, pull it out, and then insert it again to re-start the clock.
THE STRONG SUPPORT
- WARM TIPS: THE STRONG SUPPORT FROM US
- Any damages from the clock motor or clock hands that prevent the clock doesn’t work, please feel free to email us through the message center we will send a new replacement set for your clock.
- Don’t hesitate to tell us any problems of your clock, we are ready to offer the best products for you!
CUSTOMER SERVICE
- Manufacturer: Shanghaimuxinmuyeyouxiangongsi
- Address: Shuangchenglu 803nong11hao1602A-1609shi, baoshanqu, shanghai 200000 CN.
- Imported to AUS: SIHAO PTY LTD. 1 ROKEVA STREETEASTWOOD NSW 2122 Australia
- Imported to USA: Sanven Technology Ltd., Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730
- YH CONSULTING LIMITED.
- C/O YH Consulting Limited Office 147, Centurion House, London Road, Staines-upon-Thames, Surrey, TW18 4AX
- E-CrossStu GmbH
- Mainzer Landstr.69, 60329 Frankfurt am Main.
FAQ
What could I do if the clocks don't work or the clock hands are loose?
If the clocks are not functioning properly or the clock hands are loose, please follow these steps. Check the battery installation to ensure correct polarity. If the battery is correctly installed, try replacing it with a new AA battery. If the issue continues, contact customer support for assistance.
Documents / Resources
 | VEVOR SX-001 Pointer Clock [pdf] Instruction Manual SX-001 Pointer Clock, SX-001, Pointer Clock, Clock |