L-Series Track Tie-Down
Anchor Rails
Install Instructions
Parts Included:
- (2) or (4) L-Series Track Anchor Rails (option dependent)
- (4) or (8) L-Series Single Stud L-Series Anchor Fittings
- (4) RailTrax Bolts (Tundra only)
- (1) TP50 (To r x Plus 50) 3/8” Drive (Tundra only)
Step 1: Remove the OEM bed bolts utilizing a T55 (Torx 55) drive (see photo 1).
Note: OEM bed bolts that are covered in bed liner will need to be cut around the flange/washer to remove. Rest assured, the tracks will cover the exposed bed when installed.
Step 2: Position each rail between the bed bolt holes. (see photo 2).
Step 3: Install the bolts through each slot on the rails and secure directly to the frame of the vehicle.
Step 4: Torque each bolt to 50 ft/lb.
Note: Parts/positions being referenced are highlighted in blue in the photos.
Documents / Resources
 |
VERSATRAX L Series Track Tie Down Anchor Rails [pdf] Installation Guide L Series Track Tie Down Anchor Rails, L Series, Track Tie Down Anchor Rails, Tie Down Anchor Rails, Down Anchor Rails, Anchor Rails, Rails |