DIABLO CONTROLS DSP-55 Loop and Mini Loop Vehicle Detector

Loop and Mini-Loop Vehicle Detector

• The DSP-55 is a compact vehicle detector that will operate on any voltage from 8 to 35 volts DC. The low voltage range is ideal for solar applications.
• The DSP-55 can be connected to a standard inductive loop or one of Diablo Controls mini-loops. The Diablo Controls mini-loop is a small “pipe shaped” device approximately 4-1/2” by 1” and is designed to be buried in the ground to detect vehicles.
• The DSP-55 can be used as either a safety loop or free exit loop detector. It should not be used as a safety loop if used with a mini-loop. It also has the flexibility to be either “fail-safe” or “fail-secure”.
• The DSP-55 has three solid-state FET outputs called A, B and -B outputs. The two B outputs are “normal” and “inverted”. These combinations of outputs allow for the DSP-55 to be easily interfaced to a wide variety of control boards.
• The DSP-55 has 10 selectable sensitivity settings and uses a 10-position DIP switch to configure the detector. This includes delay or extension timing functions and pulse on entry or pulse on exit features.
• This makes the DSP-55 very flexible and versatile for those installations that need a little more than a standard detector.
  

  Oʻzgartirish	Funktsiya
  1	O'CHIRIB	Norm	ON	2 sek. Kechikish	O'CHIRIB	2 Sec. Extend	ON	5 Sec. Extend
  2	O'CHIRIB		O'CHIRIB		ON		ON
  3	O'CHIRIB	Muvaffaqiyatsiz			ON	Fail-Secure
  4	O'CHIRIB	Oddiy sezuvchanlik			ON	Sezuvchanlikni oshirish
  5	O'CHIRIB	B Pres	ON	B Entry Pulse	O'CHIRIB	B Exit Pulse	ON	B Fail Output
  6	O'CHIRIB		O'CHIRIB		ON		ON
  7	O'CHIRIB	Oddiy mavjudligi			ON	Kengaytirilgan mavjudlik
  8	O'CHIRIB	Induktiv halqa			ON	Mini-loop
  9	O'CHIRIB	Yuqori	ON	Med Oliy	O'CHIRIB	Med Low	ON	Past
  10	O'CHIRIB		O'CHIRIB		ON		ON

Texnik xususiyatlari

• Loop Inductance: Not specified
• Ishlash harorati: ko'rsatilmagan
• Operatsion jildtage: 8 volts to 35 volts DC
• Operating Current: Without call is 31 mA maximum, With a call is 40 mA maximum
• Output Ratings: Solid State Outputs: 250 milliamps @ 30 volt
• Enclosure: Impact resistant plastic, 2.375 (H) x 0.86 (W) x 2.25 (D) inches / 60.4 mm (H) x 22 mm (W) x 58 mm (D)

Xususiyatlari 

• Can be connected to a standard inductive loop as well as Diablo Controls mini-loops.
• Kichik profile, perfect for many installations.
• Three Solid State outputs.
• Fail-safe or Fail-secure operation.
• Wide low-voltage operatsiya
• Separate Power/Fail and Detect LEDs.
• B Outputs can be presence, pulse on entry, pulse on exit, or loop fail.
• Flicker display shows occupancy of the detection zone when operating in a pulse mode.
• Delay or extension time is possible.

Mahsulot haqida ma'lumot

The DSP-55 Loop and Mini-Loop Vehicle Detector is a compact vehicle detector that operates on a wide voltage range of 8 to 35 volts DC, making it suitable for various installations including solar applications. It can be connected to standard inductive loops or Diablo Controls mini-loops, offering flexibility in detectionmethods. The detector features three solid-state outputs, fail-safeor fail-secure operation modes, and separate Power/Fail and Detect  LEDs for easy monitoring.

O'rnatish

1. Connect the DSP-55 to the desired loop configuration based on your installation requirements.
2. Ensure proper power supply within the voltage range of 8 to 35 volts DC.

Konfiguratsiya

1. Use the 10-position DIP switch to set sensitivity levels and customize delay or extension timings.
2. Adjust the sensitivity switch to accommodate different loop sizes or mini-loops.

Chiqish sozlamalari

1. Configure the solid-state outputs A, B, and -B based on your control board requirements.
2. Output B can be set to presence, pulse on entry, pulse on exit, or loop fail modes.

Monitoring

1. Monitor the operation using the Flicker display that shows occupancy of the detection zone in pulse mode.
2. Use the separate LEDs for Power/Fail and Detect status indication.

TANLANISH XUSUSIYATLARI 

Sezuvchanlik kaliti:
This detector has a 10-position rotary sensitivity switch. The unit is shipped in the 5 position which is the normal sensitivity level. Sensitivity can be adjusted up or down from this level to accommodate different loop sizes or mini-loops.

Sozlama	0	1	2	3	4	5	6	7	8	9
%DL/L	0.48	0.32	0.24	0.16	0.12	0.08	0.06	0.04	0.03	0.02
Javob vaqti	70 ms ± 10 ms							140 ms ± 20 ms

Solid State Output A Control: Effects output A only.

1	2	Funktsiya
O'CHIRIB	O'CHIRIB	Output A has normal presence
ON	O'CHIRIB	Output A has 2 seconds of delay
O'CHIRIB	ON	Output A has 2 seconds of extension
ON	ON	Output A has 5 seconds of extension

Muvaffaqiyatsiz operatsiya:
In fail-safe, the detector will output a detect when the loop circuit is failed. In fail-secure, the detector will not output a detect when the loop circuit is failed. Set DIP switch 3 to off to operate in fail-safe mode. Set the switch to on to operate in fail-secure mode. Note: Never use a fail-secure detector for a safety loop.

3	Funktsiya
O'CHIRIB	Chiqish A xato-xavfsiz rejimida ishlaydi
ON	Chiqish A Fail-Secure rejimida ishlaydi

Sezuvchanlikni oshirish:
Set DIP switch 4 to off to operate with normal sensitivity. Set DIP switch 4 to on to automatically boost sensitivity during a call to improve detection of high-bed vehicles and truck/trailer combinations. Sensitivity boost is not applicable to most situations.

4	Funktsiya
O'CHIRIB	Detector uses normal sensitivity
ON	Detektor aniqlangandan keyin sezgirlikni oshiradi

Solid State Output B Control:
Effects output “B” only.

5	6	Funktsiya
O'CHIRIB	O'CHIRIB	B output is normal presence output
ON	O'CHIRIB	B output is an “Entry“ pulse
O'CHIRIB	ON	B output is an “Exit” pulse
ON	ON	B output is a “Fail” condition

Kengaytirilgan mavjudlik vaqti:
Set DIP switch 7 to off to hold a vehicle’s presence for about 60 minutes before tuning it out. Set the switch to on to hold it significantly longer, perhaps up to a few days.

7	Funktsiya
O'CHIRIB	Normal detection hold time
ON	Kengaytirilgan aniqlashni ushlab turish vaqti

SELECTABLE FEATURES (Continued) 

Loop turi:
Set DIP switch 8 to off to operate with a normal inductive loop. Set the switch to on to operate with a Diablo Controls mini-loop. The mini-loop mode will always be an entry pulse. As such, it is perfect for free exit operation. Never use the mini-loop as a safety loop.

8	Funktsiya
O'CHIRIB	Oddiy induktiv halqa
ON	Diablo Controls mini-loop

Chastotasi: Chastotani 9 va 10 kalitlari yordamida tanlash mumkin.

9	10	Funktsiya
O'CHIRIB	O'CHIRIB	Eng yuqori aylanish chastotasi
ON	O'CHIRIB	O'rtacha eng yuqori aylanish chastotasi
O'CHIRIB	ON	O'rtacha past aylanish chastotasi
ON	ON	Eng past aylanish chastotasi

INDIKATORLAR

Yashil quvvat LED:
The LED will be on steady to indicate the detector is powered and operating normally. If the LED is not on solid, it is indicating a current or prior fault.

Xato	Joriy uchun ekran	Oldingi uchun ko'rsatish
Kam hajmlitage	2% ish aylanishi bilan 50 Gts	YO'Q
Loopni oching	1 flash ON every 2s	1 flash OFF every 2s
Qisqartirilgan halqa	Har 2 soniyada 2 marta yonadi	Har 2 soniyada 2 ta miltillovchi O'CHIRILGAN
Katta o'zgarish	Har 3 soniyada 2 marta yonadi	Har 3 soniyada 2 ta miltillovchi O'CHIRILGAN

Red Detect A LED:
Avtomobil halqani aniqlash maydonidan oshib ketganda LED yonadi. Agar kechikish dasturlashtirilgan bo'lsa, LED kechikish oralig'ida sekin miltillaydi. Agar kengaytma dasturlashtirilgan bo'lsa, LED kengaytma oralig'ida tez miltillaydi.

Red Detect B LED:
The LED will turn on when the output B is active. If a pulse mode is selected, the LED will flicker while a vehicle is in the detection zone and the output is inactive.

ULANGAN PINLAR

www.LinearGateOpeners.com
800-878-7829
Sales@LinearGateOpeners.com

Tez-tez so'raladigan savollar

Q: Can the DSP-55 be used with solar-powered systems?
A: Yes, the DSP-55 operates on a low voltage range ideal for solar applications.

Q: How many solid-state outputs does the DSP-55 have?
A: The DSP-55 has three solid-state FET outputs named A, B, and -B.

Q: What are the different functions of the sensitivity switch?
A: The sensitivity switch offers 10 selectable settings to adjust sensitivity levels for different loop sizes or mini-loops.

Hujjatlar / manbalar

DIABLO CONTROLS DSP-55 Loop and Mini Loop Vehicle Detector [pdf] Foydalanuvchi qo'llanmasi DSP-55 Loop and Mini Loop Vehicle Detector, DSP-55, Loop and Mini Loop Vehicle Detector, Mini Loop Vehicle Detector, Loop Vehicle Detector, Vehicle Detector

Ma'lumotnomalar

• Foydalanuvchi uchun qo'llanma