USCutter Basic Stand User Guide

USCutter Basic Stand User Guide

BASIC STAND – PARTS

Step 1:

Attach the Crossbar (5) & Rollerbar Arm(1) to the Leg (3) With 2 bolts & washers form the Stand Hardware (Repeat for other side using parts 2,4,& 5).

Parts Needed:

Note: When Installing the Crossbar (5) the two
holes in the center should face up to store extra bladeholders or the

pen tool.

Step 2:

Attach the Stand Feet (6) to the Leg (3) With 2 bolts & washers from Stand Hardware (Repeat for other side using parts 4 & 6).

Parts Needed

Step 3:

Place the Rollerbar (7) in the slots on the
Rollerbar Arms (1 & 2).

Finished:

You now have a completed your Basic Stand with vinyl cutter attached.
Right Rollerbar Arm Left Rollerbar Arm Right Leg
Left Leg Crossbar Stand Feet Rollerbar

Step 4:

Place the vinyl cutter feet into the corresponding holes on the Stand Legs (3 & 4) and secure using 4 screws from the Stand Hardware.

Parts Needed:

Read More About This Manual & Download PDF: