User Guide for USCutter models including: Basic Stand, Basic, Stand

BASIC STAND SETUP - USCutter

5 Note: When Installing the Crossbar (5) the two holes in the center should face up to store extra bladeholders or the pen tool. Step 1: Attach the Crossbar (5) & Rollerbar Arm(1) to the Leg (3) With 2 bolts & washers form the Stand Hardware (Repeat for other side using parts 2,4,& 5). Parts Needed:

MH Series Basic Stand Instructions

Refurbished 34" MH100 Vinyl Cutter with Stand and Software

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized



File Info : application/pdf, 6 Pages, 1.66MB

Document Document

BASIC STAND SETUP
Ver. 1.3, May 2024

TABLE OF CONTENTS
Basic Stand - Parts .................................................................................................................................................................................... Page 3 Basic Stand - Setup .............................................................................................................................................................................. Page 4-5
2

BASIC STAND - PARTS

x8 x4
x8
Stand Hardware

1 Right Rollerbar Arm

2 Left Rollerbar Arm

3 Right Leg

4 Left Leg
5 Crossbar (Length Determined By Cutter Width)
6 Stand Feet (Left/Right) 7 Rollerbar (Length Determined By Cutter Width)
3

4

BASIC STAND - SETUP

1 3

Step 1:
Attach the Crossbar (5) & Rollerbar Arm(1) to the Leg (3) With 2 bolts & washers form the Stand Hardware (Repeat for other side using parts 2,4,& 5).
Parts Needed:

1

2

x4

3 5

Note: When Installing

the Crossbar (5) the two

4

holes in the center should

face up to store extra

bladeholders or the

5

pen tool.

5

Step 2:
Attach the Stand Feet (6) to the Leg (3) With 2 bolts & washers from Stand Hardware (Repeat for other side using parts 4 & 6).
Parts Needed:

x4

6

6 3

5

Step 3:
Place the Rollerbar (7) in the slots on the Rollerbar Arms (1 & 2).
Parts Needed:
7
Note: To install a vinyl roll put the Rollerbar (7) through the center of the vinyl roll core.

2 7
1

Step 4:
Place the vinyl cutter feet into the corresponding holes on the Stand Legs (3 & 4) and secure using 4 screws from the Stand Hardware.
Parts Needed:
4
x4

Finished:
You now have a completed your Basic Stand with vinyl cutter attached. 1 Right Rollerbar Arm 2 Left Rollerbar Arm 3 Right Leg 4 Left Leg 5 Crossbar 6 Stand Feet 7 Rollerbar
6

2 4 6

7

5

1

3

6