Uplink 5530M Cellular Communicator and Programming the Panel Installation Guide
DSC Impassa (SCW9055, SCW9057)
Wiring Uplink’s 5530M Cellular Communicator and Programming the Panel
CAUTION:
- It is advised that an experienced alarm installer programs the panel as further programming may be required to ensure proper performance and use of the full functionality.
- Do not route any wiring over circuit board.
- Full panel testing, and signal confirmation, must be completed by the installer.
NEW FEATURE: For 5530M Communicators, the status of the panel can be retrieved not only from the status PGM but now also from the Open/Close reports from the dialler.
Wiring the white wire is necessary only if the Open/Close reporting is disabled.
IMPORTANT NOTE: The Open/Close reporting needs to be enabled during the initial pairing procedure.
Wiring the 5530M communicators to DSC Impassa
Wiring the 5530M with UDM to DSC Impassa for remote upload/download
Programming the DSC Impassa Alarm Panel via the Keypad
Enable Contact ID reporting:
Program Keyswitch zone and output:
Programming the DSC Impassa Alarm Panel via the Keypad for remote Upload/Download (UDL)
Program the Panel for Upload/Download (UDL):
Documents / Resources
 |
Uplink 5530M Cellular Communicator and Programming the Panel [pdf] Installation Guide SCW9055, SCW9057, 5530M Cellular Communicator and Programming the Panel, Cellular Communicator and Programming the Panel, Communicator and Programming the Panel, Programming the Panel |
