Side Bracket Attachment Instruction
(C-Frame and T-Frame)
Instructions
FRMA-2-COM-CORE1 Side Bracket
IMPORTANT, PLEASE READ:
If your Core 1 frame box is labeled with either of the following SKUs, you will need to use this instruction sheet for the side bracket attachment section.
- FRMA-2-COM-CORE1
- FRMA-3-COM-CORE1
If your Core 1 frame box is labeled with either of the following SKUs, you can discard this instruction sheet and use the instructions received in your Core 1 frame box.
- FRM600
- FRM650
C-Frame Feet & Side Brackets Box Components
| P1 Foot (includes Leveling Glides, qty 2) |
P2 Side Bracket (right and left, qty 2) |
 |
 |
| P16 Logo Plate (qty 2) |
H1 M6x10 Machine Screw (qty 4) |
 |
 |
T-Frame Feet & Side Brackets Box Components
| P1 Foot (includes Leveling Glides, qty 2) |
P2 Side Bracket (qty 2) |
|
|
| P3 T-Frame Crossbar End Adapter (right and left qty 2) |
P16 LogoPlate (qty 2) |
 |
|
| H1 M6x10 Machine Screw (qty 4) |
H7 M8x10 Machine Screw (qty 4) |
|
 |
Side Bracket Attachment
A. Slide the tabs of the Side Bracket (P2) into the Crossbar End (P5) and insert two Machine Screws (H1) through the top of the Crossbar Endas shown. Loosely start each screwby hand, but do not tighten themcompletely.
Side Bracket Attachment (Continued)
B. Insert two more Machine Screws (H1) through the two larger holes in the face of the Side Bracket (P2) and into the Leg. Loosely start each screw by hand, but do not tighten them completely.
C. Once all four screws (H1) are started, tighten them completely.
D. Attach the Logo Plate (P16) by pressing the posts on the Logo Plate firmly into the two smaller holes in the side of the Side Bracket. The Logo Plate conceals the two screws in the face of the Side Bracket.
When assembling the Legs in the orientation shown, the Logo Plate will need to be attached upsidedown so that it is right-side-up when the desk is flipped over.
F. Repeat these steps for the second Leg assembly.
40032394v.A
AI-FRM60X-1.0
Documents / Resources
 |
UPLIFT DESK FRMA-2-COM-CORE1 Side Bracket [pdf] Instructions FRMA-2-COM-CORE1, FRMA-3-COM-CORE1, FRMA-2-COM-CORE1 Side Bracket, FRMA-2-COM-CORE1, Side Bracket |
