Uniview IPC3618LB-ADF28K-G Network Eyeball Cameras

Product Information

Specifications:

• Product Name: Network Eyeball Cameras
• Manufacturer: Zhejiang Uniview Technologies Co., Ltd
• Power Requirements: Stable voltage meeting device specifications
• Installation: Must be done by a trained professional
• Operating Environment: Proper environment meeting temperature, humidity, and ventilation requirements

Product Usage Instructions

Safety Warnings:

The device must be installed, serviced, and maintained by a trained professional with necessary safety knowledge and skills. \Before using the device, carefully read through the guide to ensure \all safety requirements are met to prevent danger and property \loss.

Storage, Transportation, and Use:

Store or use the device in an environment that meets environmental requirements such as temperature, humidity, and ventilation. Ensure the device is securely installed on a flat surface to prevent falling and provide good ventilation without covering the vents. Protect the device from liquid and ensure thepower supply meets the voltage and power requirements.

Trademark Acknowledgements:

Trademarks or registered trademarks of Uniview must be acknowledged. Do not remove seals from the device without consulting Uniview first. Always disconnect the device from power \before moving it.

About This Manual:

This manual covers multiple product models and software versions. Actual product appearances and functions may differ from the manual. Technical errors may exist, and Uniview reserves the right to change the manual without notice.

Disclaimer and Safety Warnings

Copyright Statement

©2021-2024 Zhejiang Uniview Technologies Co., Ltd. All rights reserved. No part of this manual may be copied, reproduced, translated or distributed in any form or by any means without prior consent in writing from Zhejiang Uniview Technologies Co., Ltd (referred to as Uniview or us hereafter). The product described in this manual may contain proprietary software owned by Uniview and its possible licensors. Unless permitted by Uniview and its licensors, no one is allowed to copy, distribute, modify, abstract, decompile, disassemble, decrypt, reverse engineer, rent, transfer, or sublicense the software in any form or by any means.

Trademark Acknowledgements

are trademarks or registered trademarks of Uniview.All other trademarks, products, services and companies in this manual or the product described in this manual are the property of their respective owners.

EU Authorised Representative

UNV Technology EUROPE B.V. Room 2945, 3rd Floor, Randstad 21-05 G, 1314 BD, Almere, Netherlands.

About This Manual

• This manual is intended for multiple product models, and the photos, illustrations, descriptions, etc, in this manual, may be different from the actual appearances, functions, features, etc, of the product.
• This manual is intended for multiple software versions, and the illustrations and descriptions in this manual may be different from the actual GUI and functions of the software.
• Despite our best efforts, technical or typographical errors may exist in this manual. Uniview cannot be held responsible for any such errors and reserves the right to change the manual without prior notice.
• Users are fully responsible for the damages and losses that arise due to improper operation.
• Uniview reserves the right to change any information in this manual without any prior notice or indication. Due to such reasons as product version upgrades or regulatory requirements of relevant regions, this manual will be periodically updated.

Battery Use Caution

• When battery is used, avoid:
• Extremely high or low temperature and air pressure during use, storage and transportation.
• Battery replacement.
• Use the battery properly. Improper use of the battery such as the following may cause risks of fire, explosion or leakage of flammable liquid or gas.
• Replace the battery with an incorrect type;
• Dispose of a battery into a fire or a hot oven, or mechanically crushing or cutting of a battery;
• Dispose of the used battery according to your local regulations or the battery manufacturer’s instructions.

LVD/EMC Directive

• This product complies with the European Low Voltage Directive 2014/35/EU and EMC Directive 2014/30/EU.

WEEE Directive–2012/19/EU

• The product this manual refers to is covered by the Waste Electrical & Electronic Equipment (WEEE) Directive and must be disposed of in a responsible manner.

Battery Regulation- (EU) 2023/1542

• Battery in the product complies with the European Battery Regulation (EU) 2023/1542. For proper recycling, return the battery to your supplier or to a designated collection point.

Safety Warnings

The device must be installed, serviced and maintained by a trained professional with the necessary safety knowledge and skills. Before you start using the device, please read through this guide carefully and make sure all applicable requirements are met to avoid danger and loss of property.

Storage, Transportation, and Use

• Store or use the device in a proper environment that meets environmental requirements, including but not limited to, temperature, humidity, dust, corrosive gases, electromagnetic radiation, etc.
• Make sure the device is securely installed or placed on a flat surface to prevent falling.
• Unless otherwise specified, do not stack devices.
• Ensure good ventilation in the operating environment. Do not cover the vents on the device. Allow adequate space for ventilation.
• Protect the device from liquid of any kind.
• Make sure the power supply provides a stable voltage that meets the power requirements of the device. Make sure the power supply’s output power exceeds the total maximum power of all the connected devices.
• Verify that the device is properly installed before connecting it to power.
• Do not remove the seal from the device body without consulting Uniview first. Do not attempt to service the product yourself. Contact a trained professional for maintenance.
• Always disconnect the device from power before attempting to move the device.
• Take proper waterproof measures in accordance with requirements before using the device outdoors.

Power Requirements

• Install and use the device in strict accordance with your local electrical safety regulations.
• Use a UL-certified power supply that meets LPS requirements if an adapter is used.
• Use the recommended cord set (power cord) in accordance with the specified ratings.
• Only use the power adapter supplied with your device.
• Use a mains socket outlet with a protective earthing (grounding) connection. Ground your device properly if the device is intended to be grounded.

FCC Statement

Regulatory Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Visit http://en.uniview.com/Support/Download_Center/Product_Installation/Declaration/ for SDoC.

Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Document Center

FAQ

• Q: Can I install the device myself?
  • A: No, the device must be installed by a trained professional to ensure proper setup and safety.
• Q: What should I do if I encounter technical errors?
  • A: Contact Uniview for assistance in resolving any technical issues or errors.

Documents / Resources

Uniview IPC3618LB-ADF28K-G Network Eyeball Cameras [pdf] User Guide IPC3618LB-ADF28K-G Network Eyeball Cameras, IPC3618LB-ADF28K-G, Network Eyeball Cameras, Eyeball Cameras

References

• User Manual