unitech TS100 Presentation Barcode Scanner
Installation
Horizontal Installation
Install the angle stand upward Place scanner horizontally
Pitch Forward Installation
Install the angle stand upward Pitch forward 15″
Connecting The Scanner
Connect USB cable to a free USB port of a host computer. The T$100 is now ready to use.
Test &Finish
Open a word processing program such as Microsoft Word or Notepad and scan the following barcode:
If the word “Unitech” appears on the screen, you have succesfully installed your scanner.
Description
LED Description
- A green light then a blue light: Switch on
- Blue light always on: Scanner Ready
- Green light flash once:
- Configuration commands good read
- Red light flash once: Configuration commands error
- Green light flash once: Barcode good read
Buzzer Description
- One long beep: Switch on
- One long and low beep: Configuration commands Error
- One short and low beep: Configuration commands good read
- One short and high beep: Barcode Good Read
Default Setting
Factory Default
Beeper Control
Note: The code with (*) is the factory default.
Operation Mode
We suggest using Screen-Reading Mode when scanning barcodes on the screen. (Default is Printed-Reading Mode)
Good Read Indicator
Display Version
Data Terminator
Language Settings
Documents / Resources
 |
unitech TS100 Presentation Barcode Scanner [pdf] User Guide TS100 Presentation Barcode Scanner, TS100, Presentation Barcode Scanner, Barcode Scanner |
