UNI BRIGHT Moon 800 Surface Mounted Luminaire Led 

UNI BRIGHT Moon 800 Surface Mounted Luminaire Led 

Contents hide
1 Safety
2 DIMENSIONS
3 Warning
4 Installation
5 Documents / Resources
5.1 References
6 Related Posts

Safety

For indoor use only.
This fitting should only be installed in rooms where direct contact with water is impossible.

Luminaire not suitable for covering with insulating material.

IP40  Protected against objects ≥ 1 mm. Not protected against water.

Correct disposal of this product (electrical & electronical equipment waste)

  • The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Improper installation can result in serious injuries and/or damage to property.
  • For safety and guarantee reasons it is prohibited to make any modifications to the unit.

DIMENSIONS

MN80075W White Ê 800 mm SMD LED 75W 3000K – 4000K 8000 lm
MN80075B Black Ê 800 mm SMD LED 75W 3000K – 4000K 8000 lm
Dali Driver included

Warning

  • WARNING !
    To prevent electrical shock – Always switch off electricity supply before installation and maintenance.

Installation

  • Please follow the sequence of installation step by step

Surface Mount Installation



Guidance for Wattage(Current) Selection (For MERRYTEK driver only)
Diameter Watt Rated Current LED Driver Current Selection by DIP-switch
<!) 800 40W
Table 1-Rated output power and current sets Pin 1 Pin 2 Pin 3 rated [mA]
I out mA 300 350 450 500 550
– – – 300
U min(V) 80 80 80 80 80
Um axM 330 330 266 240 219 ON – – 350
P min(W) 24 28 36 40 44 – ON – 450
P max(W) 99 115.5 120 120 120
– – ON 500
Ta[°C] 50 50 so 50 so
Tc[°C] 80 80 80 80 80 ON – ON 550
Line current, nominal@230VmA 463 540 561 561 561 – ON ON 650
Maxpower lose@230V mA 7.4 8.7 9 9 9
ON ON ON 700
input power@230VmA 106.4 124.2 129 129 129
Guidance For Wattage(Current) Selection (For OSRAM & TRIDONIC driver only)
Diameter Watt Rated Current LED Driver Current Selection by DIP–switch
<l> 800 47W 350mA
Table 1– Rated output power and current sets Pin 1 Pin 2 rated [mA]
I out(mA) 350 400 500 550
U min M 70 70 70 70 OFF OFF 350
U max [V] 217 187 150 136
P min [W] 24.5 28 35 38.5
OFF ON 400
P max [W] 77 75 75 76
Ta [°C] 50 50 50 50
ON OFF 500
Tc  [°C I 75 75 75 75
Line Current, nominal@23 0V mA 370 370 370 370
Max PowerLoss@230VfW] 6 6 6 6 ON ON 550
Input Power@230V [W] 47.3 59.1 83 83
SSW 400mA
68W S00mA
75W 550mA
<P 1000 100W 250-700mA Ready-for-use resistor between 300-700mA to set output current value(Please refer to Tridonic I-SELECT 2 PLUG PRE/ EXC for detail s)

Warning: DIP switch selection must comply with guidance, otherwise product will be overloaded!

Documents / Resources

UNI BRIGHT Moon 800 Surface Mounted Luminaire Led [pdf] Instruction Manual
Moon 800 Surface Mounted Luminaire Led, Moon 800, Surface Mounted Luminaire Led, Mounted Luminaire Led, Luminaire Led, Led

References

Related Posts

Leave a comment

Your email address will not be published. Required fields are marked *