ULINE H-2563 6' A-Frame Picnic Table Installation Guide

H-2563 6′ A-FRAME PICNIC TABLE

1-800-295-5510
uline.com

Contents hide

1 TOOLS NEEDED

2 PARTS

3 ASSEMBLY

4 Documents / Resources

4.1 References

5 Related Posts

TOOLS NEEDED

7/16″ (11 mm) Socket Bit	Phillips Head Drill Bit
Power Drill	Two Person Assembly (Optional)

PARTS

ASSEMBLY

NOTE: It is important to keep the lag screws loose throughout the assembly. Tighten during step 8.
WARNING! Do not lean on tabletop or seats when assembling.

Verify all parts are present before beginning.
Place the two A-Frame bases on a flat level surface.

Place one seat with a metal brace on each side of the A-Frame bases. Align the pre-drilled holes over the middle of the A-Frame base supports. The seat with a metal base should be flush with the end of the support.
Loosely attach seats with a metal brace to A-Frame base with the 3/” lag screws and washers using the power drill and 7/16″ socket bit (will tighten later in step 8). (See Figure 1)

Align the middle pre-drilled holes of tabletop boards to the tabletop support (different angle). Attach 31/2′ lag screws and washers using the power drill and 7/16′ socket bit. (See Figure 2)
Place the three tabletop boards on the A-Frame bases. Align the pre-drilled holes with the A-Frame base. Loosely attach tabletop board slats to A-Frame base with the 3/” lag screws and washers using the power drill and 7/16″ socket bit (will tighten later in step 8). (See Figure 3)

Loosely drill the two tabletop supports (equal angles) to the underside of the A-Frame table with the tabletop support (different angle) in the middle using 3″ deck screws (will tighten later in step 8). (See Figure 4)
Make sure the table is square and tighten all lag and deck screws. NOTE: H-6681 Mounting hardware sold separately.