tuya CF20 Smart Access and Attendance Management System User Manual
Thank you for choosing our products. We will serve you with high quality products to ensure that you use this product better, please read this manual carefully before use!
Access control wiring diagram
Department setting
Enter the menu to select “Dept.” to enter the department Settings interface.
☆ Set the name of each department, and then select “Modify User” in the user management interface to enter the User Information Modifier Department.
Shifts setting
Enter the menu and select “Shifts” to enter the shifts setting interface.
☆ Shifts setting: can set the first period of 1-24 shifts, the second period of commuting time, overtime check-in time.
☆ Attendance rules: can set the late time and early departure time.
☆ Download scheduling: insert the U disk into the USB interface, and press “OK” to download the shift table.
☆ Upload scheduling: randomly modify the downloaded scheduling form and copy it into the U disk, insert the U disk into the USB interface, and upload the scheduling form according to “OK”.
Users management
Enter the menu and select “Users” to enter the users management interface.
☆ Registered users: new users enter the work number and name, select the face / fingerprint / card / password for registration.
☆ Modify users: select “Modify” in the user management interface to enter the data modification including job number, name, department, face, fingerprint, password, card number, permission, delete the user and so on….(Except for the work number).
☆ Download data: download the user data of the device with the U disk. The U disk must use the U disk in FAT 32 format.
☆ Upload data: Upload the user data in the U disk to the device.
Download the report form
Enter the download report to select “Reports” download with U disk.
Access control
The menu selects “Settings “, and then selects “Lockctrl” for access settings.
Device Settings
The menu selects “Settings”, and then selects “Device Settings” for device settings.
Record Settings
The menu selects “Settings” and then selects “Rec.Rule” for record settings.
Disassembly diagram of the equipment
- It is recommended that the height from the base line to the ground is 1.3 m (the applicable height range is 1.5 m-1.8 m), which can be adjusted according to the overall height of the users(Image 1)
- Remove the screw at the bottom of the fuselage with a screwdriver (Image 2)
- Separate the equipment from the installation plate (Image 3)
- Attach the mounting plate to the wall (Image 4)
- align the bottom cap of the installation plate and pull it into the installation position (Image 5)
- Fixed the equipment and the bottom cover with screws (Image 6)
Documents / Resources
 |
tuya CF20 Smart Access and Attendance Management System [pdf] User Manual CF20, CF20 Smart Access and Attendance Management System, Smart Access and Attendance Management System, Access and Attendance Management System, Attendance Management System, Management System, System |