TRIPP-LITE SMART1500LCDT Lite Series 1500VA 900W Line Interactive AVR
IMPORTANT INFORMATION
Observe Proper Precautions
- Batteries can present a risk of electrical shock and burn from high short-circuit currents. Do not dispose of batteries in case of a fire. Do not open the UPS or batteries. Do not short or bridge the battery terminals with any object.
- During hot-swap battery replacement, the UPS will not provide backup power in the event of a blackout or other power interruptions.
- Do not operate UPS without the correct batteries.
PROCEDURES
Step 1
Using a Phillips screwdriver, remove the front panel’s 4 screws located on each corner.
Step 2
Disconnect the batteries from the unit.
Step 3
Remove and properly dispose of old batteries.
Note: The batteries are recyclable. For more information on battery recycling, you may check with a battery recycler in your area or contact Battery Solutions, Inc. (7266 Kensington Road, Brighton, Michigan 48116) by phoning 1 800-852-8127 or visiting their website at www.batteryrecycling.com
Step 4
Install new batteries.
Step 5
Reconnect batteries by attaching the connectors from the unit to the batteries (black-to-black and red-to-red).
Step 6
Re-attach the front panel and its 4 screws using a Phillips screwdriver.
CONTACT US
For More Information
- Visit our website www.tripplite.com
- Contact our Tech Support Team at 773.869.1234.
Documents / Resources
 |
TRIPP-LITE SMART1500LCDT Lite Series 1500VA 900W Line Interactive AVR [pdf] Instruction Manual SMART1500LCDT Lite Series 1500VA 900W Line Interactive AVR, SMART1500LCDT, Lite Series 1500VA 900W Line Interactive AVR, 900W Line Interactive AVR, Interactive AVR |