Wiring Diagram With Integrated Dali Ps

Wiring Diagram With Dali Msensor And Dali Ps

• Antenna is located on the top of the device.
  

Mains supply / DALI wires: 

• solid/fine-stranded
  

The basicDIM Wireless passive module G2 is a Bluetooth® DALI controller with 4 freely configurable push-button inputs. The module is powered by the DALI bus, no additional mains supply is needed.

Technical Data

1. Assignment of max. 4 single / group addresses, depending on the device profile.
2. Screw fixings can be removed

Safety instructions

• Installation of this device may only be carried out by specialist staff who have provided proof of their skills.
• Switch off the power supply before handling the device.
• Observe the relevant safety and accident prevention regulations.

Installation Instructions

Make sure that the mains voltage is switched off when making any connections.
Use 0.2 – 1.5 mm² solid or stranded electrical wires for the mains supply / DALI terminals and 0.14 – 0.5 mm² for the push-button terminals. Strip the wire 8.5 – 9.5 mm from the end.
Make sure to connect the input and outputs correctly.

Compatible Devices

Compatible with all Android 4.4 (KitKat) or later, iPhone 4S (iOS 5.0) or later and iPAD 3 (iOS 5.1) or later.
Hereby, Tridonic declares that the radio equipment type basicDIM Wireless Passive Module G2 is in compliance with Directive 2014/53/EU.
Hereby, Tridonic declares that the radio equipment type basicDIM Wireless Passive Module G2 is in compliance with Directive UK SI 2017 No. 1206.
The full text is available at the following internet address: https://trid.help/en28003541cer

Areas Of Application

The device may only

• be used for the applications specified.
• for safe installation in dry, clean environment.
• be installed in such a way that access is only possible using a tool

Customer Support

12/22-15014469-4 We reserve the right to make technical changes without prior notice.
Tridonic GmbH & Co KG, www.tridonic.com, info@tridonic.com, Tel. +43 5572 395-0