Trex Enhance Decking Plug System
Specifications:
- Product Name: Trex Counterbore Tool
- Color: Teal
- Compatibility: Trex decking materials
- Required Power: 18v or greater drill or impact driver
Product Usage Instructions
Installation Steps:
Preparing for Installation:
Ensure you have the following parts and tools ready: cordless drill, Trex Counterbore tool, decking screws, depth setter.
Drilling Counterbore Holes:
Using the Trex Counterbore tool, bore counterbore holes to the proper depth by drilling until the cup stops spinning. This tool can also be used for Trex Fascia Plug installations.
Installing Screws:
With the depth setter in a suitable drill or impact driver, install screws perpendicular to the board. Drive the screws into the decking until the bit releases from the screw. Ensure continuous driving without stopping.
Plugging Holes:
Remove any debris and use a Trex Enhance decking color-matched plug. Align the grain and press the plug into the hole, then tap it flush with a smooth-faced hammer.
Installation Instructions
IMPORTANT NOTES:
- For use with Trex Enhance Decking.
- Note: This counterbore tool can also be used for Trex Fascia Plug applications.
- Not recommended for use in salt environments.
- Trex Hideaway® plug systems are only compatible with Trex Plugs.
- Not for use with sleeper systems that are less than 2” thick.
- Always follow deck board manufacturer’s installation guidelines.
General Installation Recommendations:
- Always use two screws per joist or stair stringer.
- At board ends on the deck’s edge, install screws placed perpendicularly at the recommended distance, at minimum of 1″ from the board end and edge, without splitting the board.
PARTS & TOOLS NEEDED
- Using an 18V or higher cordless drill and the Trex Counterbore tool (sold separately), bore counterbore holes to the proper depth by drilling until the cup stops spinning.
NOTE: This teal counterbore tool can also be used with Trex Fascia Plug installations.
Using the HEXSTIX® depth setter in a 18v or greater drill or impact driver, install fasteners at a 90° angle (perpendicular to the board). Drive the screws into the decking untilthe bit releases from the screw.
NOTE: Drive the screw in all at once, do not stop. You will hear a change in sound when the screw is fully driven.
Clean out hole of any remaining debris and using a Trex Enhance decking color matched plug (sold separately), align the grain and press plug into the hole, and tap flush with a smooth faced hammer.
Have Questions?
1–800–BUY––TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
FAQs
Q: Where can I find more installation instructions and support?
A: For additional installation instructions and support, visit the official Trex website at trex.com
Note: Always refer to the complete user manual for comprehensive instructions and safety guidelines.
Documents / Resources
 |
Trex Enhance Decking Plug System [pdf] Installation Guide Trex Counterbore tool teal, ENT-HPLR-0052240, Enhance Decking Plug System, Decking Plug System, Plug System |