SEMI-FLEX Fixed Height Wall to Floor Stand
Instruction Manual
SEMI-FLEX Fixed Height Wall to Floor Stand
SMI-FLEX
Fixed height wall-to-floor stand
Soporte suelo-pared con altura fija
Installation manual
Failure to follow these instructions may result in accidents or the product being damaged.
SAFETY INSTRUCTIONS
GENERAL:
This product is not intended for use by young children without supervision.
If there is visible damage to the product, do not install it.
During motor use, there must be no possibility of personal injury, for example squeezing of fingers, hands or arms.
Assure free space for movement of application in both directions to avoid blockades.
For indoor use only (+10º-40º)
Before start-up:
Make sure that the system has been installed following this manual.
Make sure that the voltage of the control box is correct before connecting the system to the mains.
If the control box or the motors make unusual noise or smell, switch off the mains voltage immediately.
Take care that cables are not damaged.
Unplug the main cable on mobile equipment before moving it.
Misc.
Input: 230-240V-50Hz Max.1.8A
Output: 24V—2A(Continuous)
Output: 21V—6 (Duty cycle: 10%, 2 min on, 18 min off)
55dB (A) in typical applications
IP20
Misuse:
Do not overload the motors.
Do not use the motors for lifting persons.
Maintenance:
Unplug the mains cable before proceeding with the clearing process.
Cleaners & disinfectants must not be highly alkaline or acidic (pH 6-8).
TRAULUX
CONTENTS
TOOLS NEEDED
CHARMEX INTERNACIONAL, S.A.
C/ Maresme 103-105 – 08019 Barcelona (Spain)
C/ Miguel Faraday, 20 – 28906 Getafe (Madrid, Spain)
Parque Empresarial La Carpetania
www.traulux.net
www.charmex.net
Documents / Resources
 |
traulux SMI-FLEX Fixed Height Wall to Floor Stand [pdf] Instruction Manual SMI-FLEX, Fixed Height Wall to Floor Stand, Height Wall to Floor Stand, Wall to Floor Stand, SMI-FLEX, Floor Stand |
