TRANSGO RE4FO4 VB’s
HOLD IT! Identify the valve body first!
For RE4FO4 (Large Case) VB’s See other side.
RE4FO3 A
models: The internal solenoid wires extend outside of the case as shown below. Use SK® RE4FO3A
For Hot Rods Only:
Use RE4FO3A HD-2 Reprogramming Kit®
RE4FO3 B
models: The internal solenoid wiring harness DOES NOT extend outside of the case! Use SK® RE4FO3B
For Hot Rods Only:
Use RE4FO3B HD-2 Reprogramming Kit®
For RE4FO3 (Small Case) VB’s See other side.
RE4FO4 A&V
models: The internal solenoid wires extend outside of the case as shown below. Use SK® RE4FO4A
For Hot Rods Only:
Use RE4FO4A HD-2 Reprogramming Kit®
RE4FO4 B
models: The internal solenoid wiring harness DOES NOT extend outside of the case! Use SK® RE4FO4B
For Hot Rods Only:
Use RE4FO4B HD-2 Reprogramming Kit®
Front Drive Nissan–Without TV Cable
Sentra GXE 93-99 200SX 95-98 G20 Infinity 94-99
Upper Valve Body
You’ll love the 1- 2 shift. Short–Smooth- -No bangs
Checkballs:
Five Steel .214 to .218 Don’t use plastic balls.
Use some Vaseline to keep the checkballs in place NOT grease.
Hello Mechanic:
Install accumulator valve first. Then install the flat washer on the stem of accum valve, then the remaining parts as shown.
Upper Valve Body & Upper Separator Plate
Channel Casting
Checkballs:
Six steel .214 to .218 Don’t use plastic balls.
Use some Vaseline to keep the checkballs in place NOT grease.
Main Separator Plate
Main Valve Body
VB to Case Bolts
- “A” Six bolts 1.455”
- “B” Five bolts 1.725”
- “C” Two bolts 1.885”
Tighten VB bolts to 95 IN. LB. Pan bolts to 65-80 IN. LB. Drain plug to 25 FT. LB.
Valve Body Bolts
13 bolts necessary to remove VB from the case.
Tighten VB bolts to 95 IN. LB. Tighten hold down bolts and plates to 70-80 IN. LB.
Documents / Resources
 |
TRANSGO RE4FO4 VB's [pdf] Instruction Manual RE4FO4 VB s, RE4FO4, VB s |
