TRACEABLE 99M, 59S Timer

TRACEABLE 99M, 59S Timer

INSTRUCTION MANUAL

 

 

Usage Instructions:

Before Using:

Remove the insulating tab from the battery compartment or insert a battery to activate the device. Refer to the Battery Replacement section for detailed instructions.

Countdown Timing:
  1. Press both MIN and SEC buttons simultaneously to set the desired time.
  2. Press the START/STOP button to start the countdown.
  3. During countdown, the display will show the remaining time.
  4. When the timer reaches 00:00, the alarm will sound for 30 seconds.
  5. To manually turn off the alarm, press the START/STOP button.
    The display will return to the previously programmed time.
Timeout:
  1. The timing process can be paused at any time by pressing the START/STOP button once.
  2. To resume timing, press the START/STOP button again.

Note: During timeout, additional minutes and seconds can be added to the remaining time on the display.

All Operational Difficulties:

If the timer does not function properly, consider replacing the battery with a new high-quality one. Low battery power can cause operational difficulties. Refer to the Battery Replacement section for instructions.

Battery Replacement:

If you experience incorrect display, no display, or operational issues, it may be time to replace the battery. Follow these steps:

  1. Slide the battery compartment door on the back of the unit in the direction of the arrow to open it.
  2. Replace the worn battery with a new AAA alkaline battery following the polarity symbols in the compartment.
  3. Replace the battery cover. Replacement battery Cat. No. 1105.
Specifications:
  • Display: minutes and seconds
  • Accuracy: 0.01%
  • Resolution: 1 second
  • Timing Channels: one
  • Timing Capacity: 1 second to 99 minutes, 59 seconds
  • Alarm: Audible alarm sounds for 30 seconds
  • Memory: Automatic recall of last programmed time
  • Functions: Countdown timing
  • Attachments: Clip, magnetic back, and stand
  • Size:
  • Weight: 2 oz

WARRANTY, SERVICE, OR RECALIBRATION

For warranty, service, or recalibration, contact:

TRACEABLE® PRODUCTS
12554 Old Galveston Rd. Suite B230
Webster, Texas 77598 USA

Traceable® Products are ISO 9001:2015 Quality-Certified by DNV and ISO/IEC 17025:2017 accredited as a Calibration Laboratory by A2LA.
Cat. No. 5028
Traceable® and is a registered trademark of Cole-Parmer.
©2020 Traceable® Products. 92-5028-00 Rev. 6 062620


FAQ:

Q: How do I turn off the alarm manually?

A: You can manually turn off the alarm by pressing the START/STOP button. The display will return to the previously programmed time.

Q: What should I do if the timer does not function properly?

A: If you experience operational difficulties, consider replacing the battery with a new high-quality one as low battery power can cause issues. Refer to the Battery Replacement section for detailed instructions.

Documents / Resources

TRACEABLE 99M, 59S Timer [pdf] Instructions
99M 59S Timer, 99M 59S, Timer

References

Leave a comment

Your email address will not be published. Required fields are marked *