tp-link Omada Wall Mountable Gateways/Controllers User Guide
Wall Mounting Preparation
Before mounting the device, you need to prepare the tools below:
- A screw
- Two screws which complies to the corresponding standard. For details, see Wall Mounting Specification.
Wall Mounting Procedure
On the bottom of the panel, there are two mounting holes. You need to drive two screws into the wall, then mount the device on the wall. Note that the device should be mounted on the wall upright rather than sideways.
- Determine the location on the wall where you want to mount the
- Mark the wall where the two mounting holes The distance between the two marks must be the same as that between the two mounting holes of the device. For the wall- mounting-holes distance, see Wall Mounting Specification.
- Drive the screws into the wall at the marks using the screw driver. For the Screw- Head-to-Wall Minimum Distance, see Wall Mounting Specification.
- Mount the device on the
- Wall Mounting Specification
|
Model |
Screw Standard of
ANSI B1.1 |
Minimum Length
of Screw |
Screw-Head-to-Wall
Minimum Distance |
Wall-Mounting-Holes
Distance |
| OC220 | 4# (5#) 6# | 7mm | 1.5mm | 52mm |
| OC200 | 4# (5#) 6# | 7mm | 1.5mm | 52mm |
| ER7212PC | 4# (5#) 6# | 7mm | 1.5mm | 150mm |
| ER706W | 4# (5#) 6# | 7mm | 1.5mm | 150mm |
| ER706W-4G | 4# (5#) 6# | 7mm | 1.5mm | 150mm |
| ER706WP-4G | 4# (5#) 6# | 7mm | 1.5mm | 150mm |
| ER7206 | 4# (5#) 6# | 7mm | 1.5mm | 150mm |
| ER707-M2 | 4# (5#) 6# | 7mm | 1.5mm | 150mm |
| ER605W | 4# 6# 8# | 9.7mm | 3mm | 161.85mm |
| ER605 | 4# (5#) 6# | 7mm | 1.5mm | 122mm |
| DR3650v | 4# (5#) 6# | 7mm | 1.5mm | 150mm |
| DR3650v-4G | 4# (5#) 6# | 7mm | 1.5mm | 150mm |
Read More About This Manual & Download PDF:
Documents / Resources
 | Omada Wall Mountable Gateways/Controllers |
References
- User Manualmanual.tools
Published: July 8, 2025