tp-link Omada GPON Test Lab 2

Specifications

• Product Name: GPON Test lab 2 Guide
• Brand: Ot-link
• Test Lab: Lab2 – Create a Basic L2 Network with VLANs
• Supported VLANs: 10, 20, 1 (default VLAN)
• DHCP Pools:
  • VLAN 10: 192.168.10.1/24
  • VLAN 20: 192.168.20.1/24
  • Default VLAN: 192.168.0.1/24 (gateway default)

Product Usage Instructions

Configuration Steps:

1. 1. Create Network VLAN 10 and VLAN 20.
      • Staff_Network:
      • Guest_Network:
   2. Configure OLT:
      1. Create S_VLAN 10 & VLAN 20
         • VLAN 10:
         • VLAN 20:
      2. Config Line Profile:
         • Create a T-cont profile

FAQ

• Q: How do I verify the network configuration after setup?
  • A: Connect a device to Staff_SSID and Guest_SSID to check if the IP addresses are assigned correctly.
• Q: What should I do if the service ports are not active?
  • A: Deactivate and activate the ONU again, then ensure all service ports are active.

Lab 2: Create a Basic L2 Network with VLANs

VLAN Plan:

Port Plan:

SSID Plan:

GPON Config, Plan

Configuration Steps for OLT Service

Configuration Steps

1. Create Network VLAN 10 and VLAN 20.
   Staff_Network:
   Guest_Network:
   

Step 2: configure OLT

Step 2.1 Create S_VLAN 10 & VLAN 20

Step 2.2 config Line Profile

create a two GEM port, GEM port 1 for VLAN 10, and GEM port 2 for VLAN 20, GEM port 3 for VLAN 1

create the GEM mapping rule. Map GEM port 1 to VLAN 10, map GEM port 2 to VLAN 20, map GEM port 3 to VLAN 1

VLAN 1 is untagged in our test, make sure you have selected the untagged option

check all the setting above.

Step 2.3 create the Service Port

Create service port for staff netwokr: map C-VLAN 10 to S-VLAN 10, tag action – transparent

Create Management VLAN : map C-VLAN N/A to S-VLAN 1, tag action – Default

Step 2.4 modify the GPON Auto authentication config, choose the Line Proifle GPON_lab just created

Step 2.5 Deactive and active the ONU again.

Now you can follow the steps above to configure other ONUs.

Step 3. Configure the Switch

create switch profile for Staff_network

create Guest_Network switch profile

create Guest_Network switch profile

Step 4. bind the Staff_SSID with VLAN 10 and Guest_SSID with VLAN 20.

Verify the result:

1. connect the phone to the Staff_SSID, check if the phone can get the 192.168.10.x IP adreess.
2. connect the phone to the Guest_SSID, check if the phone can get the 192.168.20.x IP address.

Documents / Resources

tp-link Omada GPON Test Lab 2 [pdf] User Guide Omada GPON Test Lab 2, GPON Test Lab 2, Test Lab 2, Lab 2

References

• User Manual