How to unbind the slave device if the master device of the MESH suit is lost
It is suitable for ：T6,T8,X18,X30,X60
Background Introduction:
I bought a factory bound T8 (2 units), but the main device is damaged or lost. How to unbind and use the secondary device
Set up steps
STEP 1:
Power up the router and connect any LAN port of the router to the PC using a network cable
STEP 2:
Configure the computer IP as the IP address of the static 0 network segment
If unclear, please refer to: How to Configure a Static IP Address for a PC.
STEP 3:
Open the browser and enter 192.168.0.212 in the address bar to enter the management page
STEP 4:
After unbinding, the router will restore its factory settings. After completion, you can re-enter the management page through 192.168.0.1 or itoolink.net
DOWNLOAD
How to unbind the slave device if the master device of the MESH suit is lost – [Download PDF]
