EX200 Reset settings

It is suitable for: EX200

Diagram

Diagram

Diagram

Set up steps

Keep the extender power on, use a pin to press the RST button on the bottom of device. When System LED blink, release the button. The device will restore to factory default settings.

RST button diagram:

RST button

System LED diagram: 

System LED

FAQs

Q1:Unable to login the management page when I want to configure the extender to repeat other router’s signal, how to do?

Reset the extender and then login the default gateway to configure the extender again.

Q2:LED indicator introduction:

LED indicator


DOWNLOAD

EX200 Reset settings – [Download PDF]


 

References

Leave a comment

Your email address will not be published. Required fields are marked *