The Skipper Turtle Drain Plus Pump System
Specifications
- Product Name: Skipper Pump System
- Components: Turtledrain, Pump, Intake Hose
- Oil Type: Specific oil recommended by the manufacturer
- Warranty: Refer to the manufacturer’s warranty policy
INSTRUCTION
Connect the Intake Hose to the Turtledrain
The Turtledrain comes with a 1″ female adapter. Take the male end of the green intake hose, point it down toward the ground, and spin the Turtledrain counter-clockwise to thread it on securely. For a visual guide, scan the QR code at the bottom of this page or visit: https://www.youtube.com/shorts/qgI5VBEl5ZM
Connect the Intake Hose to the Pump
Attach the other end of the intake hose to the inlet on the gas-powered pump. Ensure all hose clamps and fittings are secure to prevent air leaks.
Attach the Discharge Hose
Select any of the discharge (outtake) hoses included with your gas pump. Connect it to the pump outlet and position the hose so it can drain safely away from the work area.
Place the Turtledrain in the Ponded Area
Confirm the DirtGuard is securely attached to the underside of the Turtledrain. Place the fully connected Turtledrain in the deepest part of the pond, which is not always the center. The DirtGuard ensures a stable suction surface even on uneven terrain.
Prime the Pump
Unscrew the priming cap and fill the pump housing with water until full. Optionally, pour water into the intake hose to help speed up suction. Make sure all fittings are airtight — even a small leak can break siphon.
Pump Operation & Safety
Pumps are provided via third-party vendors. Always follow the manufacturer’s manual for setup, use, and maintenance.
CRITICAL: The pump is not shipped with oil inside. You must add oil before first use, as directed by the manufacturer. Running the pump without oil will cause irreversible damage and is not covered under warranty. A bottle of oil is included in the pump’s packaging.
For Video Instructions:
Frequently Asked Questions
Q: Can I use any type of oil in the pump?
A: No, it is recommended to use the specific oil provided by the manufacturer to ensure proper functioning and avoid damage to the pump.
Q: What should I do if the pump is not working after setup?
A: Check if the intake hose is securely connected to the Turtledrain and ensure that the pump has an adequate amount of oil as per the manufacturer’s instructions.
Documents / Resources
 |
The Skipper Turtle Drain Plus Pump System [pdf] Instructions Turtle Drain Plus Pump System, Drain Plus Pump System, Plus Pump System, Pump System |