Telrad Lens Replacement Instructions

Telrad-LOGO

Telrad Lens Replacement

Telrad-Lens-Replacement-PRO

Instructions for Lens Replacement

  • Remove the adjustment plate with the mirror assembly.
  • Ensure that the area where the lens seats are clean and smooth so that the lens will sit flat.
  • Invert the unit and place the lens in its location with the convex side out.
  • Apply a small amount of ABS cement, or other suitable household cement, to the retainers and place against the inside wall of the unit and the lens in a way that fastens the lens in place.
  • Allow the cement to cure according to the manufacturer’s instructions.
  • Reassemble the mirror adjustment plate.

Telrad-Lens-Replacement-1

Documents / Resources

PDF thumbnailLens Replacement
Instructions · Lens Replacement, Replacement

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.