Tefal BL771B On the Go Blender
DESCRIPTION
- A Motor unit
- B 1 Locking ring
- 2 Powelix blades
- 3 Seal
- C 1 On-the-Go bottle 700 ml
- 2* On-the-Go bottle 400 ml
- D 1 On-the-Go bottle lid 700 ml
- 2* On-the-Go bottle lid 400 ml E Screen
- 1 Sauce function
- 2 Smoothie function
- 3 On/Off button
- 4 Ice crush function
- 5 Silence function
- 6 Pulse function
- 7 Auto clean function
- 8 Cold soup function
- 9 Plant-based milk function
- 10 Dips function
- 11 Screen
- F Cleaning brush
- G* Chopper accessory
CAUTION
The safety instructions are part of the appliance. Read these instructions carefully before using your new appliance for the first time. Keep them in an accessible place so that you can refer to them later. The appliance can only operate if the bottle is correctly positioned on the motor unit (A).
BEFORE USING YOUR APPLIANCE FOR THE FIRST TIME
Before using your appliance for the first time, wash parts that come into contact with food (bottle, etc.) with hot soapy water, then rinse.
WARNING: Do not immerse the appliance in water (neither the motor unit nor the blades unit (A and B2)). Never put the motor unit (A) under running water. Clean the appliance with a damp cloth and dry it carefully. The blades are extremely sharp.
Check that all parts of the packaging and labels have been removed before using the appliance.
ASSEMBLING AND FITTING THE ON-THE-GO BOTTLE
Moisten the seal (B3) (even if already fitted on the blades unit (B2)) by quickly running it under water. Be careful to correctly fit the seal (B3) back onto the blades unit (B2). (Fig. 1).
Add the ingredients into the bottle without exceeding the maximum level indicated:
- 700 ml for the 700 ml bottle
- 400 ml for the 400 ml bottle
Warning: Do not pour boiling liquids (over 70°C/158°F) into the bottle.
Place the blade holder with its seal (B3+B2) on the locking ring (B1) (Fig. 2). Hold the bottle and screw the locking ring onto it. (Fig. 4). Turn the bottle (C) upside down and screw the locking ring with blades onto the motor unit. (Fig. 5).
USING YOUR APPLIANCE
Put the appliance on a flat, stable, heat-resistant surface away from heat sources or water.
Add your ingredients to the bottle, screw in the blades and place the bottle correctly on the motor unit. Plug in your appliance Select your program (E) (Fig. 7) and press the Start/Stop button (E3) (Fig. 8). You can refer to the program table below to help you choose the right program for your recipe.
The appliance starts. The duration of the program until the end of its execution is displayed on the screen (E11). At the end of each automatic program, the appliance stops automatically and beeps 4 times. To stop your appliance before the automatic program ends, press the Start/Stop button (E3).
Please note : Your appliance has a Pulse function (E6).
It can be used manually when no program is running. Press and hold the button to mix. Do not exceed 3 minutes of consecutive use.
WARNING : In case of overheating, your product is equipped with a thermal fuse that will automatically stop the appliance.
After 3 minutes without use, your appliance will beep twice and start a standby mode. To switch on your appliance again, press the Start/Stop button (G).
Please note: Some coloured foods can stain the inside of the bottle (e.g. carrots). To remove stains, you can use a cloth and a little vegetable oil.
AUTOMATIC PROGRAMS AVAILABLE
OTHER PROGRAMS
WARNING: Hard foods may leave marks inside the bowl, but this does not affect the efficiency of the appliance.
ACCESSORY
AFTER USING YOUR APPLIANCE
Unplug the appliance.
Pour the mixture out of the bottle (as it is not designed to store food in the fridge or freezer), or screw the cap onto the bottle to take your mixture with you.
Use a damp cloth to clean the motor unit. Dry it carefully.
Never immerse the motor unit in water.
Wash removable parts with water and a few drops of washing-up liquid. For easier cleaning, you can use the “Auto Clean program” (E7). Pour the amount of water indicated in the program table above. You can add a drop of washing-up liquid into the bottle but nothing else. The On-the-Go bottle (C) and its lid (D) can be cleaned in the dishwasher, but the blades, seal and ring are not dishwasher safe. The motor unit must not be cleaned in the dishwasher or submerged in water.
TROUBLESHOOTING TABLE
| Problem | Cause | Solutions |
| The appliance does not work | The appliance is not properly plugged in. The bottle is not correctly locked onto the base. |
Check that the appliance is plugged in correctly. Lock the bottle properly onto the appliance base. |
| Difficulty locking the bottle onto the blade holder | There is some food in the seal | Clean the seal |
| The appliance stops when in use | Motor overheating | Unplug the appliance.Cooling time is variable and can take up to 30 minutes |
| Excessive vibrations | The appliance is not placed on a flat surface The volume of ingredients is too large |
Place the appliance on a flat surface Reduce the amount of ingredients in the appliance to the MAX level |
| Mixture leaking at the base of the bottle | The seal or blades are not correctly positioned. | Refer to the “Assembling and fitting the On-the-Go bottle” section |
| The bottle surfaces that come into contact with food are stained. | Certain foods (carrots…) may stain parts it comes into contact with. | This is normal. All parts can be used safely and do not alter cooked foods. Using oil to clean the appliance will reduce staining. |
Frequently Asked Questions
- Q: Can I wash the motor unit under running water?
A: No, never put the motor unit under running water. Clean it with a damp cloth. - Q: How do I know if the appliance overheats?
A: The product is equipped with a thermal fuse that will automatically stop the appliance in case of overheating. - Q: Is it safe to use the Pulse function for more than 3 minutes?
A: Avoid exceeding 3 minutes of consecutive use with the Pulse function.
Documents / Resources
 |
Tefal BL771B On the Go Blender [pdf] Instruction Manual BL771B, BL771C, BL771D, BL771B On the Go Blender, BL771B, On the Go Blender, the Go Blender, Go Blender, Blender |