TeeHO TE001 Keypad Deadbolt Instruction Manual
Parts List
The details of part identification is shown on following page
Prepare the door and check dimensions
Mess sure to confirm that the hole in the door is 2-1/8 (54mm)
Measure to confirm that the backset is either 2-3/8”0r 2-3/47(60 or 70mm).
Measure to confirm that the hole in the door is 1(25mm).
Measure to confirm that door thickness is between 1-3/8” and 2” (35mm to 50mm).
Choose faceplate
Is the Slotted hole centered in the door hole
Install latch and deadbolt
IMPORTANT: Keep the latch loon befog Installation
Parts identification
- Backup Key
- Exterior Assembly
- Latch
- Latch Sewers
- Strike Sewers
- Strike
- Reinforcement Plate
- Mounting Plat
- Mounting Sewers
- Interior Assembly
- Sewers
- Battery Cover
- Drive-in Collar
- Reset Tool
Install exterior assembly
Route the cable below the latch
IMPORTANT: Bolt Must be in unlock Position note horizontal orientation of torque blade.
Route the cable through the hole in the mounting plate.
Secure the mounting plate with the Supplied Sewers.
Install interior assembly
Do not load batteries until lock is completely installed.
Remove the battery Cover.
Connect the cable and ensure tight cable connection.
Rotate the Thumb turn in vertical Position and insert the horizontal orientation of torque blade into the interior assembly lock switch
Secure the interior assembly with the Supplied Secure.
Tost the lock by rotating s : 1 see if the bolt can be extended and retracte.
Documents / Resources
 |
TeeHO TE001 Keypad Deadbolt [pdf] Instruction Manual TE001 Keypad Deadbolt, TE001, Keypad Deadbolt, Deadbolt |
 |
TeeHO TE001 Keypad Deadbolt [pdf] User Guide TE001 Keypad Deadbolt, TE001, Keypad Deadbolt, Deadbolt, Keypad |
