JK Keypad Mounting Panel for
SP-8100 8 Switch Panel Power System
Installation Guide
Jeep JK Keypad Mounting Panel for SP-8100 8 Switch Panel Power System
- Temporarily upper interior above the rear while loosening the wiring attached remove the r trim piece view mirror the factory to it.
- Continue running the SP-8100 wiring harness from the engine bay area to the area above the h rear view mirror at the TTO Switch Housing
- Cut out and center template over the interior trim piece that was located above the rearview mirror
- Drill two 9/64″ holes as indicated with the template. Then drill a,/2″ hole in the center of the two 9/64″ holes using an I/2″ UNI BIT. This hole is for the wiring to transfer through
- Attach the Switch-Pro keypad bezel into the TTO housing and screw/lock in place using the two SP-8100 metal brackets.
freaky FreCIRIZiks
- This is what you should see at this point. Ready to mount the interior trim back into the Jeep.
- Congratulations You have completed the housing mounting portion of the installation. Any questions please call 720-460-1403 or email us at sales@teamtechoffroad.com
www.TeamTechOffroad.com
sales@teamtechoffroad.com
30403 Kings Valley Dr, Suite 1-113 Conifer CO, 80433 720-460-1403
Documents / Resources
 |
TEAM TECH Jeep JK Keypad Mounting Panel for SP-8100 8 Switch Panel Power System [pdf] Installation Guide Jeep JK Keypad Mounting Panel for SP-8100 8 Switch Panel Power System, Jeep JK Keypad Mounting Panel, Mounting Panel for SP-8100 8 Switch Panel Power System, SP-8100 8 Switch Panel Power System, SP-8100 Power System, 8 Switch Panel Power System |
