T-LED BLP LED Panel

WARNING

Installation can be carried out by a qualified person only

All handling with the luminaire must be carried out only when the luminaire is disconnected from the mains.

RECESSED INSTALLATION

1. Remove the required section of the suspended ceiling.
   
2. Insert the LED panel into the ceiling and connect the driver to the power supply L (brown), N (blue).
   
3. Finished installation.
   

SURFACE MOUNTED INSTALLATION

1. First, assemble three sides of the ceiling mount using screws, then secure the mount
   
2. Then, insert the LED panel into the frame and connect the driver to the power supply L (brown), N (blue).
   
3. Screw in the fourth and final part of the frame.
   
4. Finished installation.
   

SUSPENSION INSTALLATION

1. Screw the cable holders onto the ceiling.
   
2. Thread the cables through the holders and attach them to the LED panel.
   
3. Connect the driver to the power supply L (brown), N (blue).
   
4. Finished installation
   

CUSTOMER SUPPORT

www.t-led.cz
T-LED s.r.o.

Documents / Resources

T-LED BLP LED Panel [pdf] Instruction Manual BLP, ELP, UGRB, BLP LED Panel, BLP, LED Panel, Panel

References

• User Manual