sygonix 3214306 IP66 RFID/code Lock
Specifications:
- Item no.: 3214306
- IP Rating: IP66
- Default Master Code: 1234
- Code Length: 2 to 6 digits
Product Usage Instructions
Programming Mode Activation:
To activate programming mode, follow these steps:
- Enter the master code twice in standby mode (default master code: 1234).
Resetting Master Code:
To reset the master code to factory default:
- Disconnect the code lock from the power supply.
- Press and hold down the key to switch the power supply back on.
Programming Functions:
The device supports various programming functions such as:
- Programming master transponder card
- Changing the master code
- Configuring transponder cards or user codes for relay outputs
- Enabling/disabling features like backlight, beep tones, and tamper protection
User Configuration:
You can configure users, transponder cards, and relay outputs using the provided programming codes.
Overview of programming codes
RFID/code lock IP66
Item no. 3214306
Important!
All programming must be carried out in programming mode. Enter the master code twice in standby mode to activate the programming mode (“1234” by default).
To reset the master code to factory default, disconnect the code lock from the power supply.
Press and hold down the key 
to switch the power supply to the code lock back on. Press and hold down the key for three more seconds.
When the master code reset is complete, the code lock emits a short beep, and the right LED turns green.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or capturing in electronic data processing systems) requires prior written approval from the publisher. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.
Copyright 2024 by Conrad Electronic SE.
Frequently Asked Questions
How do I activate programming mode?
To activate programming mode, enter the master code twice in standby mode.
How can I reset the master code?
To reset the master code to factory default, disconnect the power supply, then reconnect it while holding down the key.
What is the default code length for this product?
The default code length is set to 4 digits.
Can I configure multiple transponder cards for relay outputs?
Yes, you can configure multiple transponder cards for relay outputs by following the programming instructions provided.
How do I enable disable features like backlight and beep tones?
To enable or disable features like backlight and beep tones, use the provided programming codes accordingly.
Documents / Resources
 |
sygonix 3214306 IP66 RFID/code Lock [pdf] Owner's Manual SY-6428612, 3214306 IP66 RFID code Lock, 3214306, IP66 RFID code Lock, RFID code Lock, code Lock, Lock |