SWH CDL-OK104 Pendent Lamp
WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Product Description
Turn Off The Power
- 1. Spread the arm to the left and right on the lamp body and adjust it to be evenly distributed.
- Put the cover on the part and tighten it.
- Pass the power cord through the iron pipe, and then screw the iron pipe into the connector on the lamp body in sequence.
- Install the movable buckle on the chain to the ring on the lamp body, and pass the wire through the chain, movable buckle, ceiling ring and ceiling plate.
- Install the ceiling plate on the junction box (J-BOX) using the mounting screws.
- Connect the lamp power cord to the mains using a wiring cap, and connect the lamp ground wire to the house ground wire using a wiring cap.
- Secure the ceiling plate to the ceiling plate using the ceiling ring.
- Install a rated wattage bulb (bulb not included).
Turn on the power
Please completely comply with this instructions and notes to ensure that the product is operated in a safe condition.
Documents / Resources
 |
SWH CDL-OK104 Pendent Lamp [pdf] Instruction Manual CDL-OK104 Pendent Lamp, CDL-OK104, Pendent Lamp, Lamp |