The Brighter Choice
SMOOTH DOWNLIGHT 4″
Install Guide and Manual
COMPONENTS
EASY INSTALLATION
1. Turn off circuit breaker that provides power to the light switch for the recessed lights.
2. Locate the housing. ·Remove previous fixture, fixture may be hot so allow time to cool after turning off power.
3. Ensure the size of the opening is 4″.
4. Determine the type of connector available. ·TP24 Connector ·E26 Base
TP24 Connector
E26 Base
5. Thread the appropriate adapter to make a connection in the housing. ·Note: the wires may come lose from the connectors so ensure they are attached.
6. Tuck all wires into the can.
7. Line up the trim ring with the opening.
8. Push downlight into can until secure. Compression clips will hold retrofit light in place.
9. Turn on circuit breaker and test light.
WARNING
All electrical connections must be in accordance with local and National Electric Code (N.E.C.) standards. Consult a qualified electrician if you are unfamiliar with proper electrical wiring connections. Please review these instructions carefully before proceeding.
WARNING: Risk of fire or electric shock. Do not alter, relocate or remove wiring during installation.
WARNING: Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation
SPECIFICATIONS
| Voltage | 120V |
| Wattage | 11W |
| Suitable for Locations Ingress | Damp |
| Housing | Aluminum+PC |
| Weight | 0.33Ibs |
| Warranty | 7 years |
Documents / Resources
 |
SUNCO Smooth downlight 4 [pdf] Installation Guide Smooth downlight 4 |
