180/220
Panel And Rack with LED
Instructions
Assembly instructions
| N° | Cod. 180 | Cad. 220 | Parts | Medida / Size + 180 | Medida / Size – 220 | Qtd. | Vol. |
| 1 | 7407 | 7344 | Upper painel | 1800x600x15 | 2195x670x15 | 1 | 1 |
| 2 | 7408 | 7345 | Lower panel | 1800x600x15 | 2195x670x15 | 1 | 1 |
| 3 | 7346 | 7346 | Larger rear bar | 1350x60x20 | 1350x60x20 | 2 | 1 |
| 4 | 7347 | 7347 | Smaller rear bar | 422x60x20 | 422x60x20 | 4 | 1 |
| 5 | 7409 | 7348 | Side rear bar | 1336x60x20 | 1196x60x20 | 2 | 1 |
| 6 | 7410 | 7349 | Vertical front rail | 862x28x20 | 734x28x20 | 2 | 1 |
| 7 | 7411 | 7350 | Horizontal front bar | 1560x28x20 | 1220x28x20 | 2 | 1 |
| 8 | 7412 | 7351 | Front panel | 1910x610x15 | 1495x540x15 | 2 | 1 |
www.gelius.com.bf
Recommendations
Attention: This product must be assembled by a professiohal.
Prepare the room before starting the assembly, leaving it completely clean and the area in good condition to start the work. Use the cardboard of the packaging to separate and support the ports removed from the boxes.
Now to use the Minifix Set (when used in the product).
Apply glues to the wooden dowels (when used in the product).
Recommended tools 
Hardwares
Attention: if the LED KIT* is purchased, it must be installed in this assembly step.
Remove the protective film from the double-sided tape and start gluing the LED tape on the side of part n° 06 in the position indicated by the arrow. Go pasting the tape by pieces n° 06, n° 07, n° 06 and finish gluing at the end of piece n° 07.
Attention: when ossembling the 180 pone!, V necessary, cut the led strip onfr in the indicated locotion. 
ATTENTION! Before starting the installation, check all the conditions of the wall, notably regarding resistance and weight support and the existence and position of hydraulic, gas and eletrical lines, avoiding damage to these structures when running holes. Gelius Moveis not responsible for problems caused by inexperience, inadequancy or failure to follow due recommendations in the assembly and installation of their products by third parties.
Define the location and height at which the panel is to be installed and mark the position of the fixing holes on the wall.
ATTENTION! When marking the position of the holes in the wall, make sure that the panel will be leveled.
With drilling machine and drill (not supplied with the product), make the holes in the wall. 
16/03/2022
Documents / Resources
 |
SUBLIME sublime220 Panel And Rack with LED [pdf] Instructions sublime220 Panel And Rack with LED, sublime220, Panel And Rack with LED, Rack with LED, LED |
