Bubuka
Welcome to the FMS RC 2.4G HT-TX02 Radio Transmitter user manual. This transmitter is designed for precise control of 1/18 scale RC vehicles, including the FJ Cruiser, K10, and HILUX models. Please read this manual thoroughly before operation to ensure safe and optimal performance.
Émbaran Kasalametan
- Always operate your RC vehicle in open areas away from people, pets, and obstacles.
- Never operate the transmitter with low batteries.
- Keep the transmitter away from water and moisture.
- This product is not a toy. Recommended for ages 14 and up.
- Disconnect the vehicle's battery when not in use.
Eusi pakét
- FMS HT-TX02 2.4G Radio Transmitter (1 unit)
- (Note: Receiver is sold separately and not included with this transmitter.)
Pamancar Leuwihview
The HT-TX02 transmitter features a standard pistol-grip design for comfortable and intuitive control.
Gambar: Hareupeun view of the FMS HT-TX02 Radio Transmitter, showing the steering wheel, throttle trigger, and main body.
Kontrol jeung Indikator
- Setir: Ngadalikeun setir kénca jeung katuhu.
- Throttle pemicu: Controls forward, brake, and reverse. Pull for forward, push for brake/reverse.
- Saklar kakuatan: Turns the transmitter ON/OFF.
- Indikator LED: Shows power status and binding status.
- Motong setir: Adjusts the neutral steering position.
- Motong throttle: Adjusts the neutral throttle position.
- Tombol Ngabeungkeut: Used for pairing with a compatible receiver.
Disetél
1. Pamasangan batré
The HT-TX02 transmitter requires 4x AAA batteries (not included).
- Open the battery compartment cover on the bottom of the transmitter.
- Pasangkeun 4 batré AAA anyar, pastikeun polaritasna bener (+/-).
- Tutup panutup kompartemen batré aman.
Awas: Ulah campur accu heubeul jeung anyar. Ulah gaul batré basa, standar (karbon-séng), atawa rechargeable (nikel-kadmium).
2. Binding the Transmitter to a Receiver
This transmitter operates on a 2.4GHz frequency and must be bound to a compatible FMS 2.4G receiver (sold separately) before use.
- Ensure the transmitter batteries are installed and the power switch is OFF.
- Connect the receiver to your RC vehicle's Electronic Speed Controller (ESC) and power source.
- Turn ON the receiver power. The receiver's LED should flash, indicating it is waiting for a binding signal.
- While holding down the BIND button on the transmitter, turn ON the transmitter's power switch.
- Continue holding the BIND button until the LED indicator on both the transmitter and receiver turns solid, indicating a successful bind.
- Release the BIND button.
- Turn OFF both the transmitter and receiver, then turn them ON again to confirm the binding.
If binding fails, repeat the steps. Ensure the transmitter and receiver are close to each other during the binding process.
Parentah Operasi
Ngahurungkeun
- Turn ON the transmitter first.
- Then, turn ON the receiver/vehicle power.
penting: Always power on the transmitter before the vehicle and power off the vehicle before the transmitter to prevent loss of control.
Kadali dasar
- Setir: Rotate the steering wheel clockwise for right turns, counter-clockwise for left turns.
- Throttle: Pull the trigger towards you for forward movement. Push the trigger away from you for braking, and further for reverse.
Pangaturan motong
Trim controls allow fine-tuning of the steering and throttle neutral positions.
- Motong setir: If the vehicle pulls left or right when the steering wheel is centered, adjust the steering trim dial until the vehicle tracks straight.
- Motong throttle: If the vehicle creeps forward or backward when the throttle trigger is at neutral, adjust the throttle trim dial until the vehicle remains stationary.
Pangropéa
- beberesih: Use a soft, dry cloth to clean the transmitter. Avoid using solvents or harsh chemicals.
- Panyimpenan: Store the transmitter in a cool, dry place away from direct sunlight. Remove batteries if storing for extended periods to prevent leakage.
- Perawatan batré: Replace batteries when the LED indicator shows low power. Dispose of used batteries responsibly.
Pamérésan masalah
| Masalah | Mungkin Cukang lantaranana | Solusi |
|---|---|---|
| Pemancar teu hurung. | Batré paéh atawa salah dipasang. | Pariksa polaritasna batré; ngaganti ku accu seger. |
| Kandaraan teu ngaréspon ka pemancar. | Not bound; low transmitter/receiver battery; out of range. | Perform binding procedure; replace batteries; ensure vehicle is within operating range. |
| Vehicle steers incorrectly. | Trim setirna pareum. | Adjust steering trim until the vehicle tracks straight. |
spésifikasi
- model: HT-TX02
- Frékuénsi: 2.4GHz
- Saluran: 2 (Steering, Throttle)
- Sasayogian tanaga: 4 x Batré AAA (teu kalebet)
- ukuran: Kira-kira 4.7 x 2.7 x 4.5 inci (119 x 69 x 114 mm)
- Umur Disarankeun: 14 taun ka luhur
- Kasaluyuan: FMS 1/18 FJ Cruiser, K10, HILUX RC vehicles (requires compatible receiver)
Garansi sareng Rojongan
This FMS product is manufactured by RC BAR. For warranty information and technical support, please refer to the documentation provided with your purchase or contact your retailer. Keep your proof of purchase for warranty claims.
Pikeun pitulung salajengna, anjeun tiasa nganjang ka RC BAR Store on Amazon.
