Overstock 3-Light Vanity Light with Brushed Nickel Finish and Bath Set

Bubuka

This manual provides detailed instructions for the safe installation, operation, and maintenance of your Overstock 3-Light Vanity Light and accompanying 5-Piece Bath Set. Please read this manual thoroughly before beginning installation and retain it for future reference.

Émbaran Kasalametan

PERHATOSAN: Résiko Setrum Listrik. Pegatkeun sambungan kakuatan dina circuit breaker atawa kotak sekering saméméh instalasi atawa ngalayanan.

• All electrical connections must be in accordance with local codes and ordinances, National Electric Code (NEC), and ANSI/NFPA 70-1999.
• Taroskeun ka tukang listrik anu mumpuni upami anjeun henteu yakin kana prosés pamasangan.
• Ulah sambungkeun fixture ieu ka sistem listrik ungrounded.
• Nanganan komponén kaca kalayan ati-ati pikeun nyegah pegatna.
• Pastikeun sadaya sambungan aman sareng leres sateuacan malikkeun kakuatan.

Eusi pakét

Carefully unpack your product and ensure all items listed below are present and undamaged. If any parts are missing or damaged, do not attempt to assemble or install the product. Contact customer service for assistance.

• 3-Light Vanity Light Fixture (Brushed Nickel Finish)
• Clear Glass Shades (3)
• Bar anduk
• Cingcin anduk
• Toilét Paper Holder
• Kait Jubah
• Pamasangan Hardware Kit
• Instruksi Manual

Setup sareng Instalasi

Professional installation is recommended for electrical fixtures. If you are performing the installation yourself, ensure you follow all safety guidelines.

Alat Diperlukeun (Teu Kaasup):

• Phillips Kepala Obeng
• Obeng Kepala Datar
• Kawat Strippers
• Pita listrik
• Tang
• Kacamata Kasalametan
• Tangga (upami diperyogikeun)

Vanity Light Installation Steps:

1. Pareuman Daya: Locate the circuit breaker that supplies power to the light fixture outlet box. Turn off the power. Verify the power is off using a voltage panguji.
2. Nyiapkeun Wiring: Carefully pull the electrical wires from the outlet box. Identify the hot (black), neutral (white), and ground (bare copper or green) wires.
3. Ngagantelkeun Plate Pemasangan: Secure the mounting plate to the outlet box using the provided screws. Ensure the plate is level.
4. Jieun sambungan listrik: Connect the fixture's black wire to the outlet box's black (hot) wire, the fixture's white wire to the outlet box's white (neutral) wire, and the fixture's ground wire to the outlet box's ground wire. Secure connections with wire nuts and wrap with electrical tape.
5. Perlengkapan Gunung: Carefully push the connected wires back into the outlet box. Align the fixture base with the mounting plate and secure it with the provided screws.
6. Pasang Kaca Shades: Gently attach the clear glass shades to the fixture. Ensure they are securely fastened.
7. Pasang Bulbs: Insert incandescent bulbs (not included) of up to 60-Watt into each socket. Do not exceed the maximum wattage.
8. Mulangkeun Daya: Turn the power back on at the circuit breaker. Test the light fixture.

Bath Set Installation Steps:

The bath set components (towel bar, towel ring, toilet paper holder, robe hook) typically install using wall anchors and screws. Specific instructions may vary slightly by component, but the general process is as follows:

1. Pilih Lokasi: Select appropriate locations on your wall for each accessory. Use a level to ensure proper alignment.
2. Tanda titik pangeboran: Hold the mounting bracket of each accessory against the wall and mark the screw hole locations with a pencil.
3. Bor Pilot liang: Drill pilot holes at the marked points. Use a drill bit appropriate for your wall type (e.g., drywall, tile). Insert wall anchors if necessary.
4. Gantelkeun kurung dipasang: Ngamankeun kurung ningkatna kana témbok ngagunakeun screws disadiakeun.
5. Gantelkeun Asesoris: Slide or screw the main accessory body onto its mounting bracket, securing it with set screws if applicable.

Parentah Operasi

The 3-Light Vanity Light is designed for use with standard incandescent bulbs up to 60-Watt. It is compatible with a dimmer switch (not included) to allow for adjustable light intensity and to create a desired ambiance. Ensure the dimmer switch is rated for incandescent loads.

The bath set components are fixed accessories designed for holding towels, toilet paper, and robes. No specific operational instructions are required beyond their intended use.

Pangropéa

beberesih:

• Always disconnect power before cleaning the light fixture.
• Wipe the fixture and bath set components with a soft, dry cloth.
• Ulah make cleaners abrasive, pangleyur, atawa polishes sabab bisa ngaruksak finish.
• For glass shades, use a mild glass cleaner applied to a cloth, not directly to the shade.

Ngagantian bohlam:

• Ensure the power is off at the circuit breaker before replacing bulbs.
• Keun bohlamna tiis sagemblengna sateuacan dirampa.
• Cabut bohlam anu lami ka arah anu sabalikna tina arah jarum jam.
• Screw in the new bulb clockwise. Use A19 type incandescent bulbs, maximum 60-Watt.

Pamérésan masalah

spésifikasi

Garansi sareng Rojongan

This product is manufactured by Overstock. For specific warranty information, please refer to the documentation included with your purchase or contact Overstock customer service directly. Warranty terms typically cover defects in materials and workmanship for a specified period from the date of purchase.

For technical support or assistance with parts, please contact the retailer where the product was purchased. If purchased from Amazon, you may contact BED BATH & BEYOND, the seller for this product.

Sumberdaya Online: For additional information or frequently asked questions, please visit the official Overstock website or the product page on the retailer's websitus.