1. Bubuka
Thank you for choosing the HOFTRONIC LED Batten Light. This fixture is designed for high efficiency and durability, providing 5280 lumens of 3000K warm white light. Its IP65 rating ensures resistance to dust and water splashes, making it suitable for a wide range of indoor and outdoor applications, including workshops, warehouses, basements, bathrooms, offices, and garages. The flicker-free technology ensures comfortable illumination, and the fixture is connectable, allowing multiple units to be linked together for larger areas.
2. Émbaran Kasalametan
- Kasalametan listrik: Salawasna pegatkeun daya dina pemutus sirkuit utama sateuacan nyobian masang, pangropéa, atanapi perbaikan naon waé.
- Personil anu mumpuni: Installation should only be performed by qualified adults with knowledge of electrical systems.
- Voltage: Mastikeun suplai voltage cocog sareng volume anu ditangtukeun ku produktage (220-240V AC).
- Lingkungan: Do not install in environments exceeding the specified operating temperature range (-20°C to +40°C).
- Ruksakna: Ulah ngoperasikeun alatna upami ruksak. Hubungi dukungan palanggan pikeun kéngingkeun bantosan.
3. Eusi Paket
Pariksa yén sadaya komponén aya sateuacan ngamimitian pamasangan:
- 1x HOFTRONIC LED Batten Light Fixture (housing with G13 fitting)
- 2x LED Fluorescent Tubes (T8, 150cm)
- 1x LED Starter (for retrofitting)
- Mounting accessories (screws, wall anchors, stainless steel mounting brackets)
4. Setup jeung Instalasi
Turutan léngkah ieu pikeun instalasi anu leres:
- Nyiapkeun pikeun Instalasi: Ensure the power supply is completely disconnected at the main circuit breaker.
- Open the Fixture Housing: To access the internal wiring and mounting points, locate the two plastic nipples on the top ends of the metal cover of the lamp housing. Rotate these nipples to unlock and remove the metal cover.
- Pasang Perlengkapan: Using the provided screws and wall anchors, securely attach the stainless steel mounting brackets to your desired installation surface. Then, clip the batten light fixture into the brackets.
- Kawat Fixture: Connect the main power supply cables (Live, Neutral, Earth) to the terminal block inside the fixture. Ensure all connections are secure and correctly polarized.
- Pasang Tabung LED: Insert the two LED fluorescent tubes into the G13 fittings inside the fixture. Ensure they are firmly seated.
- Install LED Starter: If retrofitting a traditional fixture, replace the existing starter with the included LED starter.
- Close the Fixture Housing: Carefully re-attach the metal cover and rotate the plastic nipples back to their locked position to seal the housing.
- Mulangkeun Daya: Saatos pamasangan réngsé sareng sadaya sambungan parantos aman, balikkeun deui daya dina pemutus sirkuit utama.
5. Parentah Operasi
Once installed and powered, the HOFTRONIC LED Batten Light operates by a standard wall switch connected to its power supply. There are no additional controls on the fixture itself.
- Hurungkeun/Pareuman: Anggo saklar témbok pikeun ngaktipkeun atanapi mareuman lampu.
- Fitur Linkable: Multiple HOFTRONIC LED Batten Lights can be connected in series to operate simultaneously from a single power source. Refer to the wiring diagram (if provided separately) for detailed instructions on linking multiple units.
6. Pangropéa
Lampu Batten LED HOFTRONIC peryogi pangropéa minimal.
- beberesih: Pegatkeun sambungan kakuatan saméméh beberesih. Ngagunakeun lemes, damp lawon pikeun ngusap bagian luar perlengkapan. Entong nganggo pembersih atanapi pangleyur anu abrasif.
- Panggantian Tabung LED: The LED tubes are replaceable. If a tube fails, disconnect power, open the housing as described in Section 4, remove the old tube, and insert a new compatible T8 LED tube. Ensure the replacement tube is suitable for the fixture's specifications.
7. Cara ngungkulan
If you encounter issues with your LED Batten Light, refer to the following common troubleshooting steps:
- Lampu teu hurung:
- Pariksa catu daya di circuit breaker.
- Verify all electrical connections are secure and correct.
- Ensure the LED tubes are properly seated in their fittings.
- Check if the LED starter is correctly installed.
- Cahaya kedip-kedip:
- Ensure the fixture is not connected to an incompatible ballast (see Figure 4).
- Pariksa sambungan leupas.
- Ngurangan Caang:
- Ensure the fixture and tubes are clean.
- Verify the correct type of LED tubes are installed.
If these steps do not resolve the issue, contact HOFTRONIC customer support.
8. Spésifikasi
| Fitur | Spésifikasi |
|---|---|
| merek | HOFTRONIC |
| Nomer modél | 549524 |
| Masukan Voltage | 220-240V AC |
| Konsumsi Daya | 48 W (2x 24W LED tubes) |
| Fluks Luminous | 5280 lm |
| Efficacy Luminous | 110 lm/W |
| Suhu Warna | 3000 K (Bodas Haneut) |
| Indéks Rendering Warna (CRI) | > 80 Ra |
| Sudut Beam | > 80 Ra (Note: This value seems incorrect as a beam angle, likely a data entry error. Typically beam angle is in degrees.) |
| Faktor kakuatan | > 0.90 |
| Peunteun panyalindungan | IP65 (Kedap lebu, ditangtayungan tina jet cai) |
| Dimmable | No |
| Bahan | Plastik ABS / Polikarbonat (PC), Aluminium |
| Ukuran (L x W x H) | 1572 x 102 x 73 mm |
| Suhu Operasi | -20 °C nepi ka +40 °C |
| Rata Kahirupan | 30,000 jam |
| Beurat | 5 kg |
| Sertifikasi | CE, RoHS |
| Kelas Énergi Énergi | F (View EPREL Data) |
9. Garansi jeung Rojongan
The HOFTRONIC LED Batten Light comes with a 3-year warranty as stated in the product description. Some marketing materials may indicate an extended warranty of up to 10 years, please refer to your purchase documentation for specific warranty terms applicable to your product.
For technical support, warranty claims, or further assistance, please contact HOFTRONIC customer service through your retailer or the official HOFTRONIC websitus.
