Bubuka
The House of Marley Stir It Up Wireless Turntable offers a premium vinyl listening experience with the convenience of Bluetooth connectivity. Crafted with sustainable materials, this turntable features a built-in pre-amp, two-speed belt drive, and a replaceable Audio Technica cartridge, delivering superior audio quality for your favorite records.
Image: The Stir It Up Wireless Turntable connected to House of Marley speakers, showcasing its design and connectivity.
Émbaran Kasalametan
- Read all instructions before operating the turntable.
- Keep the turntable away from water or moisture.
- Ulah meungpeuk sagala bukaan ventilasi.
- Paké ngan kantétan / asesoris dieusian ku produsén.
- Cabut colokan turntable nalika hujan badag atawa nalika teu dianggo dina waktu anu lila.
- Rujuk sadayana jasa ka tanaga jasa anu mumpuni.
Eusi pakét
Pastikeun yén sadaya komponén aya dina kotak:
- House of Marley Stir It Up Wireless Turntable
- Adaptor kakuatan
- RCA Kabel
- Kabel USB
- Plat Muter
- Silicone Slip Mat
- Drive Belt (often pre-installed or located around the platter)
- counterweight
- 45 RPM Adaptor
- Rewind Fabric Dust Cover
Produk Leuwihview
Gambar: Top view highlighting key components including Solid Aluminum Platter, Regrind Silicone Pad, Anti-Skating Control, Replaceable Audio Technica Cartridge, Headphone Jack, and 33/45 RPM speed selector.
Gambar: Tukangeun view showing the RCA (Phono/Line) output, Built-in Pre-Amp switch, USB to PC Recording port, and the Rewind Fabric material.
Guide Setup
- Unpacking sareng Penempatan: Carefully remove all components from the packaging. Place the turntable on a stable, level surface away from direct sunlight, heat sources, and excessive vibration.
- Pamasangan Platter sareng Sabuk:
- Place the aluminum platter onto the center spindle.
- Locate the small rubber drive belt. If it's around the center of the underside of the platter, gently stretch it around the gold motor spindle located on the turntable base. Ensure it is seated correctly.
- Place the Regrind Silicone Slip Mat on top of the platter.
- Pamasangan counterweight: Slide the counterweight onto the rear of the tonearm. Rotate it clockwise until it is approximately in the middle of the tonearm.
- Nyukcruk gaya adjustment:
- Cabut pelindung stylus kalayan ati-ati.
- Lower the tonearm lift lever.
- Balance the tonearm by rotating the counterweight until the tonearm floats freely and is parallel to the platter.
- Sakali saimbang, cekel beurat panyeimbang ajeg teras puterkeun cincin anu dinomeran ka '0'.
- Rotate the entire counterweight (including the numbered ring) counter-clockwise to the recommended tracking force for the Audio Technica AT3600L cartridge, which is typically 3.5 grams.
- Penyesuaian Anti-Skate: Set the anti-skate dial to the same value as your tracking force (e.g., 3.5). This helps prevent the stylus from skipping inwards.
- Sambungan Audio:
- Kaluaran RCA: Connect the included RCA cable from the turntable's 'OUT PUT' jacks to your amplifier atanapi speaker Powered.
- pra-Amp Pindah: Lamun nyambung ka hiji amplifier with a dedicated 'PHONO' input, set the 'PRE-AMP' switch on the back of the turntable to 'OFF'. If connecting to an 'AUX' or 'LINE' input, set the 'PRE-AMP' switch to 'ON'.
- Sambungan Daya: Connect the power adapter to the '12V DC' input on the back of the turntable and plug it into a wall outlet.
Parentah Operasi
Maénkeun Rékaman
- Teundeun rékaman vinyl dina platter nu.
- Select the appropriate speed (33 or 45 RPM) using the speed selector knob. Use the 45 RPM adapter for singles if needed.
- Angkat tonearm nganggo tuas angkat tonearm.
- Posisikeun tonearm sacara manual di luhur alur awal rekaman anu dipikahoyong.
- Gently lower the tonearm using the lift lever. The stylus will make contact with the record and playback will begin.
- At the end of the record, the turntable will automatically stop spinning. Lift the tonearm and return it to its rest.
Papasangan Bluetooth
- Pastikeun spiker Bluetooth atanapi headphone anjeun dina modeu papasangan.
- Hurungkeun turntable.
- Press the Bluetooth button on the turntable to activate Bluetooth mode. The indicator light will flash.
- Press the Bluetooth button again to initiate pairing. The turntable will search for nearby Bluetooth devices.
- Sakali disambungkeun, lampu indikator Bluetooth bakal jadi padet.
Ngagunakeun Headphone Jack
Plug your headphones into the 3.5mm headphone jack located on the front of the turntable for private listening.
USB ka Rékam PC
Connect the turntable to your computer using the USB cable. Use appropriate recording software (not included) to digitize your vinyl collection.
Perawatan sareng Pangropéa
- beberesih: Use a soft, dry cloth to clean the turntable's surface. For the bamboo plinth, a slightly damp lawon bisa dipaké, dituturkeun ku anu garing. Ulah make bahan kimia anu keras.
- Perawatan Stylus: Gently clean the stylus regularly with a soft brush designed for stylus cleaning, brushing from back to front. Avoid touching the stylus with your fingers.
- Panutup lebu: Use the included Rewind Fabric Dust Cover to protect the turntable from dust when not in use.
- Ngaganti sabuk: The drive belt may need replacement over time. Refer to the setup guide for re-installation instructions with a new belt.
Pamérésan masalah
| Masalah | Mungkin Cukang lantaranana | Solusi |
|---|---|---|
| Teu aya sora atanapi volume handap | Incorrect PRE-AMP switch setting; loose cables; ampmasalah liifier / spiker. | Ensure PRE-AMP switch is set correctly (ON for AUX/LINE, OFF for PHONO). Check all cable connections. Verify amplifier / spiker kakuatan sarta volume. |
| Skipping atawa sora menyimpang | Incorrect tracking force/anti-skate; dirty stylus; damaged record; turntable not level. | Re-adjust tracking force and anti-skate. Clean the stylus. Inspect the record for damage. Ensure the turntable is on a level surface. |
| Turntable stops playing mid-record | Auto-stop mechanism sensitivity; record groove variations. | This can sometimes occur with certain records due to variations in the run-out groove. Ensure the tonearm is properly balanced and tracking force is set. If persistent, contact support. |
| Bluetooth teu nyambung | Device not in pairing mode; too far from turntable; interference. | Ensure your Bluetooth device is in pairing mode and close to the turntable. Re-initiate pairing on the turntable. Turn off other Bluetooth devices nearby. |
| Motor noise audible | Operasi normal; résonansi. | A slight motor hum can be normal. Ensure the turntable is on a stable, non-resonant surface. If noise is excessive, contact support. |
spésifikasi
- Ukuran produk: 15.74 x 15.74 x 3.15 inci
- Beurat barang: 12.13 pon
- Jumlah modél: EM-JT002-BK
- merek: Marley
- Laju Rotasi Maksimum: 45 RPM (ngadukung 33 1/3 sareng 45 RPM)
- Fitur husus: Diwangun-di Pra-Amp, RCA Output, USB Recording, Bluetooth Connectivity
- Bahan: Wood (Natural Bamboo), Aluminum, REGRIND Silicone, REWIND Fabric
- warna: Signature Hideung
- Alat anu cocog: Speakers, Bluetooth Audio Devices
- Cartridge: Replaceable Audio Technica AT3600L MM cartridge
Sustainability and Materials
The House of Marley Stir It Up Wireless Turntable is designed with a commitment to sustainability, incorporating mindfully sourced materials to minimize environmental impact.
Image: Close-up of the natural bamboo material used in the plinth, highlighting its sustainable origin.
- Natural Bamboo: The plinth is crafted from solid bamboo, a rapidly renewable resource.
- REGRIND Silicone: The slip mat is made from REGRIND silicone, utilizing recycled silicone waste.
- REWIND Fabric: The dust cover and other fabric elements are made from REWIND fabric, a blend of recycled materials including organic cotton, hemp, and recycled PET.
- Recycled Aluminum: The platter is made from recycled aluminum.
House of Marley's commitment extends to global reforestation and ocean conservation through partnerships with organizations like One Tree Planted and the Surfrider Foundation.
Garansi sareng Rojongan
This product comes with a manufacturer's warranty. For specific warranty terms and conditions, please refer to the documentation included with your purchase or visit the official House of Marley websitus.
For technical support, troubleshooting assistance, or to inquire about replacement parts, please contact House of Marley customer service through their official websitus atanapi inpormasi kontak anu disayogikeun dina bungkusan produk anjeun.
Anjeun oge bisa nganjang ka Marley Store on Amazon pikeun émbaran produk tambahan jeung sumber rojongan.
