Manual+

Sunco Lighting SHW-40W-5K-2PK

Sunco LED Wraparound Shop Light Instruction Manual

Model: SHW-40W-5K-2PK | Brand: Sunco Lighting

Bubuka

Thank you for choosing the Sunco LED Wraparound Shop Light. This manual provides essential information for the safe installation, operation, and maintenance of your new lighting fixture. Please read these instructions thoroughly before installation and retain them for future reference.

Émbaran Kasalametan

Eusi pakét

Pariksa yén sadaya komponén aya sateuacan ngamimitian pamasangan:

spésifikasi

Nomer modélSHW-40W-5K-2PK
Konsumsi Daya40 Watt
Kaluaran cahaya3500 Lumén
Suhu Warna5000K Beurang
Voltage120-277V
Diménsi48 "L x 5.35" W x 2.36" H
Sudut Beam110-gelar
CRI80+
Tipe PamasanganFlush Mount / Hardwired
Fitur hususPrismatic Lens, Linkable (up to 8 units), Non-Dimmable
SertifikasiETL

Parentah instalasi

This fixture is designed for direct surface mounting to the ceiling. Always ensure power is disconnected before starting installation.

  1. Nyiapkeun Fixture: Carefully remove the diffuser (Part B) from the lamp base (Part A) to access the wiring and mounting points.
  2. Pasang Perlengkapan: Posisi lamp base against the ceiling where you intend to install it. Mark the mounting holes. Use appropriate mounting hardware (screws, anchors) to securely attach the lamp base to the ceiling.
  3. Wiring: Bring the electrical supply wires from the junction box to the fixture. Connect the wires according to local electrical codes: Black to Black (Live), White to White (Neutral), Green/Bare Copper to Green (Ground). Ensure all connections are secure with wire nuts.
  4. Replace Diffuser: Once wiring is complete and secure, carefully reattach the diffuser to the lamp base. Ensure it snaps firmly into place along both sides.

Linking Multiple Fixtures

These fixtures are linkable, allowing you to connect up to 8 units from a single power source. Use the provided linking cables or flush linking connectors to connect fixtures end-to-end. Ensure the total wattage tina perlengkapan anu numbu henteu ngaleuwihan kapasitas sirkuit.

Diagram showing three steps for easy installation: removing diffuser, wiring, and reattaching diffuser and mounting.
Figure 1: Easy Installation Steps. This image illustrates the three primary steps for installing the Sunco LED Wraparound Shop Light: 1. Removing the diffuser (Part B) from the lamp base (Part A). 2. Connecting the electrical wires from the fixture to the junction box. 3. Replacing the diffuser and mounting the shop light directly onto the ceiling or wall.
Diagram showing two methods of linking multiple shop lights: using an 8-inch linking cable and a 1.5-inch flush linking connector.
Figure 2: Daisy Chain Linkability. This diagram demonstrates how to connect multiple Sunco LED shop lights. The top illustration shows connecting lights using an 8-inch linking cable, while the bottom shows a 1.5-inch flush linking connector for a seamless, continuous appearance. Up to 8 lights can be connected to a single power source.

Operasi

Once properly installed and powered, the Sunco LED Wraparound Shop Light will provide instant-on, flicker-free illumination. This fixture is non-dimmable and operates at a 5000K Daylight color temperature, designed to mimic natural daylight for enhanced visibility and alertness.

Image showing a person holding a smartphone displaying a brightly lit room, with an inset graphic highlighting 'Instant-on Technology' and 'Flicker-Free Lights'.
Figure 3: Flicker-Free Lights. The fixture features instant-on technology and provides flicker-free illumination, which helps minimize eye strain and fatigue, improving visual comfort in various environments.
Image of a parking garage with a blue car, highlighting the 5000K Daylight color temperature of the lights, with an inset showing the light source.
Figure 4: 5000K Daylight. The 5000K Daylight color temperature mimics natural daylight indoors, promoting alertness and enhancing visibility, making it ideal for workshops, garages, and other utility spaces.

Pangropéa

The Sunco LED Wraparound Shop Light is designed for long-lasting performance with minimal maintenance. The integrated LED design means there are no bulbs to replace.

Text 'Never change a tube again!' with icons for 110-degree wide beam angle and 45+ years lifespan, set against an image of a modern office with many ceiling lights.
Figure 5: Long Lifespan. Designed to last over 45+ years under typical usage conditions, eliminating the need for frequent bulb replacements.

Pamérésan masalah

If you experience issues with your Sunco LED Wraparound Shop Light, refer to the following common problems and solutions:

MasalahMungkin Cukang lantarananaSolusi
Lampu teu hurungNo power supply; Loose wiring; Faulty fixture.Check circuit breaker/fuse. Ensure all wire connections are secure. If problem persists, contact Sunco support.
Cahya taram atawa kedip-kedipIncompatible dimmer switch (fixture is non-dimmable); Loose wiring; Power fluctuation; Fixture nearing end of life.Ensure no dimmer switch is used. Check wiring connections. If dimming occurs after extended use (e.g., 1.5-2 years), it may indicate a component issue. Contact Sunco support for warranty assistance.
Only some linked lights are workingLoose linking cable connection; Faulty individual fixture in the chain.Check all linking cable connections. Isolate the non-working fixture to determine if it's an individual unit issue.

Upami léngkah-léngkah ngungkulan masalah henteu ngabéréskeun masalah, mangga ngahubungi dukungan palanggan Sunco Lighting.

Garansi sareng Rojongan

Sunco Lighting stands behind the quality of its products. This LED Wraparound Shop Light comes with a 7-Taun Protection warranty. For warranty claims, technical assistance, or any questions regarding your product, please contact our knowledgeable support specialists.

Inpormasi kontak: Please refer to the Sunco Lighting websitus atanapi dokuméntasi pameseran anjeun pikeun detil kontak anu paling anyar.

Video: Get to know Sunco. This official video from Sunco Lighting provides an overview of the company's commitment to quality, product testing, and customer service, highlighting their dedication to customer satisfaction and product reliability.

Dokumén Patali - SHW-40W-5K-2PK

Praview Sunco cahaya 2x2 LED Selectable Panel siling Manual Instalasi
Pituduh instalasi komprehensif pikeun Sunco cahaya 2x2 LED Panel siling dipilih (PN22_DU-WH-4060K). Diajar kumaha cara masang sareng kabel anu aman sareng hémat énergi, lampu LED anu tiasa dimmable sareng wat anu tiasa dipilihtage jeung pilihan suhu warna.
Praview Panduan Pemasangan Fixture Strip LED Siap Sunco Lighting 4ft: Kabel Ujung Tunggal & Ganda
Pitunjuk pamasangan pikeun Perlengkapan Strip Siap LED Sunco Lighting 4ft, anu ngawengku kabel ujung tunggal sareng ujung ganda, peringatan kaamanan, sareng pilihan pamasangan. Pituduh ieu ditujukeun pikeun tukang listrik anu mumpuni.
Praview Sunco Lampu Industrial Toko Lampu Instalasi Guide na Manual
Pitunjuk instalasi komprehensif sareng manual pikeun Sunco Lighting Industrial Shop Light, kalebet komponén, gantung sareng pamasangan langsung dipasang, peringatan kaamanan, sareng spésifikasi.
Praview Sunco Lampu Industrial Toko Lampu Instalasi Guide na Manual
Pitunjuk instalasi komprehensif sareng manual pikeun Sunco Lighting Industrial Shop Light, kalebet komponén, gantung sareng pamasangan langsung dipasang, peringatan kaamanan, sareng spésifikasi.
Praview Sunco Lampu LED Panel siling 40W Pasang Guide na Manual
Pituduh instalasi komprehensif sarta manual pikeun Sunco cahaya 40W Panel siling LED. Ngawengku duanana recessed na gantung ningkatna, warnings kaamanan, diagram wiring, sarta spésifikasi teknis. Dirancang pikeun instalasi profésional.
Praview VTW NSF uap Parentah Instalasi Lampu Kedap | Cahaya Sunco
Pituduh pamasangan komprehensif pikeun VTW NSF Vapor Tight Light ku Sunco Lighting. Diajar kumaha cara masang sareng kabel anu aman sareng dipasangkeun lampu LED anu disertipikasi NSF ieu.