Zoom H6 Six-Track Portable Recorder Instruction Manual

1. Produk Langkungview

The Zoom H6 is an advanced portable recorder designed for high-quality audio capture. It features a system of interchangeable input capsules, allowing for versatile microphone configurations. The device supports simultaneous recording across multiple tracks and offers flexible input options for various audio sources.

fitur konci ngawengku:

• Direct recording to SD cards up to 128GB.
• Gain knobs, pads, and phantom power for each input.
• Newly redesigned preamps with an ultra-low noise floor.
• Up to 24-bit/96kHz audio recording in WAV or MP3 format.
• Multichannel and stereo USB audio interface for PC/Mac/iPad.
• Includes XYH-6 X/Y capsule, MSH-6 MS capsule, AA batteries, USB cable, sponge windscreen, and Cubase LE software.

Figure 1: Zoom H6 Recorder with the XYH-6 X/Y capsule installed.

2. Setélan

2.1. Nyelapkeun Batré

The Zoom H6 operates on 4 AA batteries. To insert them:

1. Tangtukeun lokasi kompartemen batré dina pungkur alat.
2. Geser panutup batre kabuka.
3. Selapkeun 4 batré AA, mastikeun polaritasna bener (+/-).
4. Tutup panutup batre aman.

2.2. Inserting hiji Kartu SD

The H6 records directly to SD cards. It supports cards up to 128GB.

1. Tangtukeun lokasi slot kartu SD di sisi alat.
2. Insert a compatible SD card until it clicks into place.
3. Pikeun ngaluarkeunnana, pencét kartu lalaunan.

2.3. Attaching Microphone Capsules

The H6 comes with interchangeable capsules. The XYH-6 X/Y capsule and MSH-6 MS capsule are included.

1. Align the desired capsule with the connector on top of the H6.
2. Slide the capsule onto the connector until it locks into place.
3. To remove, press the release button and slide the capsule off.

Figure 2: Zoom H6 with interchangeable microphone capsules.

2.4. Connecting External Microphones/Line Inputs

The H6 features four XLR/TRS combo inputs for external microphones or line-level devices.

1. Connect your XLR or TRS cables to the corresponding inputs (1-4) on the side of the H6.
2. If using condenser microphones requiring phantom power, enable it in the device settings (see Section 3.2).

Figure 3: Zoom H6 with external microphones connected to XLR/TRS inputs.

3. Parentah Operasi

3.1. Powering on / Pareum

To power on the H6, press and hold the power button located on the side until the screen illuminates. To power off, press and hold the power button until the shutdown prompt appears, then confirm.

3.2. Adjusting Input Levels and Phantom Power

Each input (1-4 and the attached capsule) has a dedicated gain knob. Use these to set appropriate recording levels.

• Gain Knobs: Rotate to adjust the input sensitivity. Monitor the level meters on the display to avoid clipping.
• Bantalan: If an input signal is too strong even with the gain at minimum, engage the -20dB pad switch for that channel.
• Kakuatan Phantom: For condenser microphones, phantom power (+12V/+24V/+48V) can be enabled per channel through the menu settings.

3.3. Ngarékam Audio

The H6 supports up to six tracks of simultaneous recording.

1. Select the desired input channels for recording by pressing their respective arm buttons.
2. Adjust the input levels using the gain knobs and pads.
3. Pencét éta REC button once to enter record standby mode.
4. Pencét éta REC button again to start recording.
5. Pencét éta EUREUN tombol pikeun ngeureunkeun ngarékam.

3.4. Ngawas Audio

You can monitor your audio during recording or playback.

• Headphone: Connect headphones to the 3.5mm headphone jack on the side of the device. Adjust headphone volume using the dedicated volume control.
• Speaker Diwangun-di: The H6 has a small built-in speaker for quick playback review.
• Jalur Kaluar: Use the 3.5mm Line Out jack to send audio to an external device like a camera or mixer.

Gambar 4: Sisi view of Zoom H6 showing headphone and line out connections.

3.5. USB Audio Interface Functionality

The H6 can function as a multi-channel or stereo USB audio interface for computers (PC/Mac) and iPads.

1. Connect the H6 to your computer or iPad using the supplied USB cable.
2. Select the desired USB mode (Audio Interface or Storage) on the H6 display.
3. Configure your computer's or iPad's audio settings to use the H6 as the input/output device.

4. Pangropéa

• Keep the device clean by wiping it with a soft, dry cloth. Avoid using liquid cleaners.
• Store the H6 in a cool, dry place away from direct sunlight and extreme temperatures.
• Do not expose the device to very high humidity or allow it to be splashed by water.
• Cabut batré upami alat moal dianggo kanggo waktos anu panjang pikeun nyegah bocor.

5. Cara ngungkulan

5.1. Alat Teu Bisa Dihurungkeun

• Check if the batteries are inserted correctly and are not depleted.
• Ensure the power button is pressed and held sufficiently long.
• If using USB power, ensure the USB cable is securely connected and the power source is active.

5.2. Henteu aya Rekaman Audio

• Verify that an SD card is inserted and has sufficient free space.
• Ensure the desired input channels are armed for recording.
• Check microphone connections and ensure phantom power is enabled if required.
• Adjust gain levels to ensure the input signal is not too low.

5.3. Poor Audio Quality (Distortion/Noise)

• Reduce input gain levels if the level meters are consistently peaking (going into the red). Engage the -20dB pad if necessary.
• Ensure microphone cables are in good condition and securely connected.
• Avoid recording in environments with excessive background noise.

6. Spésifikasi

Figure 5: Detailed specifications for the Zoom H6 Recorder.

7. Garansi jeung Rojongan

Kanggo inpormasi garansi sareng dukungan téknis, mangga tingal Zoom resmi websitus atanapi ngahubungan layanan palanggan maranéhanana langsung. Simpen bukti pameseran anjeun pikeun klaim garansi.