Korg MS20 Mini Semi-Modular Analog Synthesizer (MS20MINI) Instruction Manual

2.1. Ngabongkar sareng Inspeksi Awal

Carefully remove the MS20 Mini from its packaging. Inspect the unit for any signs of damage. Ensure all included accessories are present. Note that some components, such as audio cables, may not be included and need to be acquired separately.

2.2. Sambungan Daya

Connect the provided power adapter to the DC 9V input on the rear panel of the MS20 Mini. Plug the adapter into a suitable power outlet.

Image: Rear panel of the Korg MS20 Mini, showing the DC 9V power input, MIDI IN, and USB port.

2.3. Kaluaran Audio

Connect the audio output of the MS20 Mini to your amplifier, mixer, or audio interface using appropriate cables. The unit features a standard 1/8" output jack.

2.4. Konéktivitas MIDI

The MS20 Mini supports both USB MIDI and 5-pin MIDI. Connect a USB cable from the synthesizer to your computer for MIDI communication, or use 5-pin MIDI cables to connect to other MIDI-equipped instruments.

3.1. Basic Sound Generation

The Voltage Controlled Oscillator (VCO) is the primary source of sound for the MS20 Mini. Adjust the waveform and pitch controls in the VCO sections (VCO 1 and VCO 2) to begin shaping your sound. The VCO Mixer allows you to blend the outputs of VCO 1 and VCO 2.

Image: Close-up of the Korg MS20 Mini's control panel, highlighting the Voltage Controlled Oscillators (VCOs) and filter sections.

3.2. Filter Control

The MS20 Mini features self-oscillating high-pass and low-pass filters. Use the CUTOFF FREQUENCY and PEAK controls in both the Voltage Controlled Highpass Filter (VCF) and Voltage Controlled Lowpass Filter (VCLPF) sections to sculpt the timbre of your sound. Experiment with resonance to create distinctive tonal qualities.

3.3. Generators amplop

Two Envelope Generators (EG 1 and EG 2) control the amplitude and filter modulation over time. Adjust the ATTACK TIME, DECAY TIME, SUSTAIN LEVEL, and RELEASE TIME parameters to create dynamic sound envelopes, from sharp percussive hits to long, evolving pads.

3.4. Patching System

The flexible patching system allows for extensive sound design. Use patch cables to reroute signals between different modules, enabling complex modulation and unique sound textures. Refer to the included manual for detailed patching examples.

Image: Close-up of the Korg MS20 Mini's patch bay, illustrating connections with patch cables.

3.5. External Signal Processor (ESP)

The External Signal Processor (ESP) allows you to process external audio signals through the MS20 Mini's filters and envelopes. This expands the synthesizer's capabilities, enabling it to act as a powerful audio effect unit.

Image: Close-up of the Korg MS20 Mini's External Signal Processor (ESP) section.

3.6. Démonstrasi Pidéo