Leviton 15 Amp 120 Volt Duplex Combination Switch/Receptacle 5225 User Manual

Bubuka

This manual provides detailed instructions for the safe installation, operation, and maintenance of your Leviton 15 Amp, 120 Volt, Duplex Style Combination Single Pole Switch/Receptacle, Model 5225. This device combines a single-pole switch and a 15 Amp, 125 Volt grounding receptacle in a single unit, designed for commercial and residential applications.

Émbaran Kasalametan

PERHATOSAN: Pikeun ngahindarkeun seuneu, shock, atawa maot, pareuman kakuatan dina circuit breaker atawa kotak sekering jeung nguji yén kakuatan pareum saméméh wiring. Alat ieu kedah dipasang saluyu sareng sadaya kode listrik nasional sareng lokal.

• Salawasna pegatkeun sambungan kakuatan saméméh gawe dina sirkuit listrik.
• Anggo ngan ukur kawat tambaga atanapi kawat anu dilapis tambaga. Ulah nganggo kawat aluminium sareng alat ieu.
• Pastikeun sadaya sambungan kabel aman.
• Upami anjeun henteu yakin kana bagian mana waé tina pitunjuk ieu, konsultasi ka tukang listrik anu mumpuni.
• Alat ieu kanggo dianggo di jero rohangan wungkul.

Eusi pakét

• One Leviton 15 Amp, 120 Volt, Duplex Style Combination Single Pole Switch/Receptacle (Model 5225-W)

Setup sareng Instalasi

1. Pareuman Daya: Locate the circuit breaker or fuse that supplies power to the outlet box where you intend to install the device. Turn it OFF. Verify power is off using a voltage panguji.
2. Remove Old Device (if applicable): Carefully remove the existing switch or receptacle from the wall box. Disconnect the wires, noting their connections.
3. Siapkeun Kawat: Strip approximately 1/2 inch (12.7 mm) of insulation from each wire end. Ensure wires are straight.
4. Identipikasi Terminal: The Leviton 5225 device has the following terminals:
   • Screw taneuh héjo: For the bare copper or green insulated ground wire.
   • Silver Screws: For neutral (white) wires.
   • Brass Screws: For hot (black) wires.
   • Break-off Tabs: Located on the side of the device, these tabs connect the switch and receptacle to the same hot feed. If you need to control the switch and receptacle from separate power sources, carefully break off the tab connecting the brass screws.
5. Sambungan Kawat:

   Kawat taneuh: Connect the bare copper or green insulated ground wire from the wall box to the green ground screw on the device. Tighten securely.

   Kawat nétral: Connect the white neutral wire from the wall box to one of the silver screws. Tighten securely.

   Hot Wire (Power In): Connect the black hot wire (power source) from the wall box to one of the brass screws. Tighten securely.

   Load Wire (for Switch): If the switch controls a light fixture or other load, connect the load wire to the remaining brass screw. If the switch and receptacle are on the same circuit, and the break-off tab is intact, the switch will control the receptacle. If the tab is broken, the switch will control a separate load connected to its brass screw, and the receptacle will be constantly powered.
6. Alat Gunung: Carefully fold the wires into the wall box. Secure the device to the wall box using the provided mounting screws.
7. Pasang Wallplate: Attach a standard wallplate (not included) over the device.
8. Mulangkeun Daya: Hurungkeun kakuatan deui ON di circuit breaker atawa kotak sekering.
9. Tes: Test the switch and receptacle functionality.

Gambar 1: Hareupeun view of the Leviton 5225 combination switch and receptacle, showing the single pole switch at the top and the 15 Amp receptacle below.

Gambar 2: Balik view of the Leviton 5225, illustrating the brass (hot), silver (neutral), and green (ground) wiring terminals, along with the break-off tab. The UPC 0078477965849 is visible.

Parentah Operasi

The single-pole switch operates by toggling the lever up or down to control the connected load. The 15 Amp receptacle functions as a standard electrical outlet for plugging in devices. If the break-off tab is intact, the switch will control power to the receptacle. If the tab is removed, the switch and receptacle operate independently.

Pangropéa

This device requires minimal maintenance. Periodically inspect the device and wallplate for any signs of damage or wear. Clean with a soft, dry cloth. Do not use abrasive cleaners or solvents.

Pamérésan masalah

• No Power to Receptacle/Switch: Check the circuit breaker or fuse. Ensure all wire connections are secure.
• Switch Not Controlling Receptacle: Verify that the break-off tab between the brass screws is intact if you intend for the switch to control the receptacle.
• Sambungan Leupas: If the device feels loose in the wall box, ensure mounting screws are tightened.

spésifikasi

Gambar 3: Sisi view of the Leviton 5225, showing approximate dimensions of 4.4 inches (11 cm) in length.

Émbaran jaminan

Leviton provides a limited two-year warranty for this device. For specific details regarding warranty coverage and claims, please refer to the official Leviton websitus atanapi ngahubungan rojongan customer.

Ngarojong

For technical assistance, product information, or customer service, please visit the official Leviton website or contact their customer support department. You can find contact information and additional resources at www.leviton.com.