Manual Instruksi Filter EHEIM Classic Canister 2213 (Klasik 250)

1. Bubuka jeung Leuwihview

The EHEIM Classic Canister Filter 2213, also known as the Classic 250, is an external aquarium filter designed for efficient mechanical and biological water purification. This filter is suitable for aquariums up to 66 US gallons, providing continuous water circulation and oxygen enrichment to maintain a healthy aquatic environment. Its robust design and proven technology ensure reliable performance.

2. Parentah Kasalametan

• Always disconnect the filter from the power supply before performing any maintenance, cleaning, or installation procedures.
• Ensure all electrical connections are dry and away from water. Do not operate the filter with a damaged power cord or plug.
• This appliance is intended for indoor use only and for filtering aquarium water. Do not use it for other liquids or purposes.
• Keep the filter and all components out of reach of children and pets.
• Ensure the filter is placed on a stable, level surface below the aquarium water level to facilitate proper operation and priming.
• Never run the filter dry. Always ensure it is filled with water before connecting to power.

3. Komponén Kaasup

Your EHEIM Classic Canister Filter 2213 package typically includes the following items:

• EHEIM Classic Canister Filter unit
• Filter sponges (coarse and fine)
• EHEIM Mech (ceramic rings for mechanical filtration)
• EHEIM Substrat Pro (sintered glass for biological filtration)
• Bar nyemprot
• Inlet pipe with strainer
• Hose (intake and output)
• Installation accessories (suction cups, clips)
• Pareum valves
• Silicone sealing ring (pre-installed on pump head)

4. Setup jeung Instalasi

Follow these steps to properly set up your EHEIM Classic Canister Filter:

4.1. Prepare Filter Media

1. Open the filter canister by releasing the clips and removing the pump head.
2. Rinse all filter media (EHEIM Mech, Substrat Pro, sponges) thoroughly under tap water to remove any dust or debris.
3. Place the media into the canister in the recommended order, typically: coarse sponge at the bottom, followed by EHEIM Mech, then Substrat Pro, and finally the fine filter pad at the top, just below the pump head.
4. Ensure the permo-elastic silicon sealing ring on the pump head is clean and properly seated.
5. Securely reattach the pump head to the canister using the clips.

4.2. Sambungan selang

1. Cut the provided hose into two appropriate lengths for the intake and output lines. Measure carefully to ensure they reach from the filter to the aquarium without excessive slack or tension.
2. Connect one end of the intake hose to the inlet pipe (with strainer) and the other end to the filter's intake connection (usually at the bottom of the pump head).
3. Connect one end of the output hose to the spray bar and the other end to the filter's output connection (usually at the top of the pump head).
4. Install the shut-off valves on both the intake and output hoses, close to the filter, for easy disconnection during maintenance.
5. Securely attach the inlet pipe and spray bar inside the aquarium using the provided suction cups.

Figure 1: Assembled EHEIM Classic Canister Filter 2213. This image shows the complete filter unit with its dark green canister and black pump head, ready for hose connections.

4.3. Priming Filter nu

Priming is essential to fill the filter with water and remove air before starting. Ensure the filter is placed below the aquarium water level.

1. Ensure both shut-off valves on the hoses are open.
2. Submerge the intake pipe fully into the aquarium water.
3. To initiate water flow, you can use one of the following methods:
   • Suction Method: Place the output hose end into a bucket below the filter. Briefly suck on the end of the output hose to create a siphon. Water will begin to flow from the aquarium, through the filter, and into the bucket. Once water flows steadily, quickly place the output hose end back into the aquarium (e.g., connect to the spray bar).
   • Fill Method: Carefully fill the filter canister with treated aquarium water before securing the pump head. Then, open the valves and allow gravity to fill the hoses.
4. Once the filter canister and hoses are filled with water and no large air bubbles are visible, plug the filter into a grounded electrical outlet.
5. The filter should start operating. If you hear gurgling noises, gently rock the filter from side to side to help trapped air escape through the output.

Figure 2: EHEIM Classic Canister Filter 2213 with approximate dimensions. This image illustrates the height of the filter unit, which is approximately 14 inches (36 cm).

5. Parentah Operasi

Once installed and primed, the EHEIM Classic Canister Filter operates continuously to maintain water quality. Ensure the filter is always submerged in water and never runs dry. The flow rate is generally fixed, providing consistent filtration. Monitor the water flow from the spray bar; a reduced flow indicates that maintenance may be required.

6. Pangropéa

Regular maintenance is crucial for the longevity and efficiency of your filter. The frequency depends on your aquarium's bioload.

1. Pegatkeun Daya: Always unplug the filter from the electrical outlet before starting any maintenance.
2. Nutup Katup: Close both shut-off valves on the intake and output hoses to prevent water backflow and spills.
3. Pegatkeun sambungan hoses: Carefully disconnect the hoses from the filter unit.
4. Transport Filter: Move the filter to a suitable location (e.g., a sink or bucket) for cleaning.
5. Buka kaleng: Release the clips and remove the pump head.
6. Média bersih:
   • Rinse mechanical filter media (coarse sponge) in old aquarium water (from a water change) to preserve beneficial bacteria.
   • Biological media (EHEIM Substrat Pro) should only be gently rinsed in old aquarium water if heavily clogged, to avoid disturbing the bacterial colony.
   • Replace fine filter pads and carbon pads (if used) as needed, typically every 2-4 weeks or when visibly dirty.
7. Clean Canister and Pump Head: Clean the inside of the canister and the pump head, including the impeller chamber, with a brush. Ensure the permo-elastic silicon sealing ring is clean and free of debris.
8. Pasang deui: Reassemble the filter in reverse order, ensuring all connections are secure and the sealing ring is correctly seated.
9. Uihan deui: Reconnect hoses, open valves, and prime the filter as described in Section 4.3 before plugging it back in.

7. Cara ngungkulan

8. Spésifikasi

• Ngaran modél: EHEIM FILTER 250 CLASSIC 2213-37
• Jumlah modél: 2213371
• merek: Ehem
• UPC: 720686221390
• Ukuran produk (L x W x H): 8 x 6.3 x 13.98 inci (20.3 x 16 x 35.5 cm)
• Beurat barang: 4.5 Pon (2.04 kg)
• Bahan: Durable plastics, silicone
• warna: Héjo jeung Hideung
• Ukuran akuarium anu disarankeun: Up to 66 US Gallons
• Sertifikasi Tés Éksternal: CE
• fungsi: Mechanical and Biological Water Purification

9. Émbaran jaminan

The EHEIM Classic Canister Filter 2213 comes with a garansi 2 taun from the date of purchase. This warranty covers defects in materials and workmanship under normal use. Please retain your proof of purchase for any warranty claims. For detailed terms and conditions, refer to the official Eheim warranty documentation or contact Eheim customer support.

10. Rojongan jeung Kontak

For further assistance, technical support, or to inquire about replacement parts, please visit the official Eheim websitus atanapi hubungi departemén layanan palangganna. Pastikeun anjeun gaduh nomer modél produk anjeun (2213371) sareng rinci pameseran nalika milarian dukungan.

You can often find additional resources, FAQs, and contact information on the manufacturer's websitus: www.eheim.com

11. Video Produk Resmi

No official product videos from the seller were found that meet the specified criteria for embedding (m3u8 format or "preview" videos from seller).