STOBAG EC6300 Electric Components Installation Guide

STOBAG EC6300 Electric Components

Specifications

• Product Name: Electric Components EC6300
• Manufacturer: TinLine GmbH
• Model: EC6300

Product Usage Instructions

Safety Instructions
Before connecting the system, read and observe the following safety instructions:

1. Check the unit for any damage as soon as it is unpacked.
2. Ensure safe operation can be guaranteed before use.
3. Electric installation on site must be done by authorised electricians.
4. Make electric connections accessible and switch off when necessary.
5. Wiring work must be done with the power disconnected.
6. Operate only with a downstream ground fault circuit interrupter, max. 30mA Type A.
7. Observe local regulations and protective measures.

Installation Instructions
Follow the installation and assembly instructions provided:

1. Respect the specified protection class for undamaged and complete housing.
2. Dispose of the product according to applicable legal provisions.

FAQ
Q: What should I do if I notice any damage to the unit?
A: If any damage is noticed, do not use the unit and contact the manufacturer or a professional technician for assistance.

Q: Can I perform the electrical installation myself?
A: No, the electric installation on site must be undertaken by authorised electricians to ensure safety and proper functioning.

Electric Components EC6300

Electrical schema and safety instructions

safety instructions

• The following safety instructions must be read and observed before connecting the system. Failure to do so may result in danger to persons or damage to the system.
• Check the unit for any damage as soon as it is unpacked
• If it is ascertained that safe operation cannot be guaranteed it must be taken out of service immediately and secured from unintentional operation
• The electric installation on site must be undertaken by authorised electricians
• Make the electric connections in such a way that they are always accessible and can be switched off
• Wiring work must be performed with the power disconnected
• The stipulated protection class is only featured for undamaged and complete housing
• Operation only with a downstream ground fault circuit interrupter, max. 30mA Type A.
• Local regulations and protective measures must be observed
• Follow the installation and assembly instructions.
• Any disposal must be performed according to the applicable legal provisions.

Installation