STI-LOGO

STI SA5500 Select Alert Mini Controllers

STI-SA5500-Select-Alert-Mini-Controllers-PRODUCT

Specifications

  • Input: 9 VDC Battery, 527 mA Max. or 12-24 VDC, 402 mA Max.
  • Dimensions:
    • Length: 3.73 in. (94.6 mm)
    • Width: 3.87 in. (98.2 mm)

Product Usage Instructions

Battery Installation/Replacement:

  1. Unscrew the lens to remove it.
  2. Loosen the PCB screws without removing them.
  3. Gently rotate the PCB without touching the LEDs or damaging the reflectors.
  4. Connect the battery and slide it under the retainer.
  5. Re-install the PCB and tighten the screws securely.

Low Battery Notification/Strobe Control:

Replace the battery when a low battery condition occurs. The low battery LED will flash once per minute, and the sounder will beep once every 3 minutes.

PRODUCT OVERVIEWSTI-SA5500-Select-Alert-Mini-Controllers-FIG-2

INPUT
9 VDC Battery, 527 mA Max.
12-24 VDC, 402 mA Max.
OPERATING TEMPERATURE
-4°F to 140°F (-20°C to 60°C)

BATTERY INSTALLATION/REPLACEMENT

  1. Unscrew lens to remove.
  2. Loosen PCB screws (do not remove).
  3. Gently rotate PCB without touching LED’s and without damaging the reflectors.
  4. Connect battery and slide under the retainer.
  5. Reinstall the PCB and tighten the screws.

NOTES

  1. The internal battery will provide backup power if loss of external power.
  2. If no internal battery is used, remove all power and move S1-1 to the “OFF”  position (see detail S1).

LOW BATTERY OPERATON
Replace battery when low battery condition occurs, Low battery LED flashes 1x per 1 minute and sounder beeps 1x per 3 minutes

STI-SA5500-Select-Alert-Mini-Controllers-FIG-1

S1 – LOW BAT. NOTIFICATION/STROBE CONTRO

STI-SA5500-Select-Alert-Mini-Controllers-FIG-8

WARNING: This product can expose you to chemicals including Dichloromethane, which is known to the State of California to cause cancer, and Bisphenol A (BPA), which is known to the State of California to cause birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov. Three-year warranty or a one-year limited warranty (from date of purchase) on most products. See website for details.

Electronic warranty form at www.sti-usa.com/wc14.STI-SA5500-Select-Alert-Mini-Controllers-FIG-93

  • Control with Power Supply
    Not supervised
    Alarm on close
    Turn off low battery notification
  • Power Supply Plus Battery
    Supervised trigger
    Alarm on open trigger
    Low battery detect on
  • Battery Only
    Supervised trigger
    Alarm on open trigger
    Low battery detect onSTI-SA5500-Select-Alert-Mini-Controllers-FIG-5 STI-SA5500-Select-Alert-Mini-Controllers-FIG-6

STI-SA5500-Select-Alert-Mini-Controllers-FIG-7

FAQ

Q: What should I do if I encounter a low battery situation?

A: When the low battery condition occurs, replace the battery promptly to ensure continued functionality of the device.

Q: Can I use an external power supply with this product?

A: Yes, you can use either a 9 VDC battery or a 12-24 VDC power source with a maximum current rating of 402 mA.

Documents / Resources

STI SA5500 Select Alert Mini Controllers [pdf] Installation Guide
SA5500, 5501, SA5500 Select Alert Mini Controllers, SA5500, Select Alert Mini Controllers, Alert Mini Controllers, Mini Controllers

References

Leave a comment

Your email address will not be published. Required fields are marked *