SQM DL-4112T Remote Control
INSTALLATION INSTRUCTION
- ” LOW, MED, HI” buttons:
These three buttons are used to set the fan speed as follows: LOW= Low speed MED= Medium speed HI= High speed - “
” button:
This button turns the fan off. - ”
” button:
This button will make forward or reverse the fan. - The ”
” button turns the light ON orOFF . Press and release the button to turn the light ON or OFF
Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device.
The term “IC:” before the radio certification number only signifies that Industry Canada Technical specifications were met. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
