Speedy Bee Master 5 V2 Frame

CNC camera mount and camera side plate installation

Antenna Installation Sequence

• insert the O-ring into the antenna to secure it on the TPU antenna base.

Install the multi-function antenna base

Note: pictures for assembly reference only. The frame doesn’t include an antenna)

1. Install the plate on one side and the GPS base
2. Install the T-shaped antenna
3. Choose a suitable VTX antenna base
4. Install the plate on the other side

Install arms and anti-vibration module

(Complete the installation of 4 arms in turn)

1. Screws pass through the bottom plate and the intersection position of the arms in turn
2. Install the anti-vibration stack module to the corresponding position
3. Install the screws on both sides in the same way
4. Install 4 arms in the same way

Install middle plate

1. Install the middle plate to the corresponding 6 screw positions
2. Tighten the two press-in nuts where the arms intersect

Combination with completed parts 1 and 2

1. Combination of frame and CNC camera mount
2. Install 7075 stand-off

Install the rear top plate and battery anti-slip silicone

Arm foot mount installation

1. Install the 3D-printed foot mount to the arms
2. Use a screw of proper length based on the motor installation

(*Notice: default screws are M3*8mm, M3*10mm)

Air Unit Installation Method

• Pass through the top of the VTX

The 4 original screws at the bottom of the O3 Air Unit need to be removed

Recommend installing ESC in reverse horizontally 180°

Note (After the ESC is installed reversely, remember to the correct position and direction of motors 1-4.)
It is recommended to keep the power cable of ESC to about 100mm. Please refer to the used battery for the actual length.

• Scan the QR code to get the installation guide.
• We recommend you scan it through the SpeedyBee App for detailed instructions.

Documents / Resources

Speedy Bee Master 5 V2 Frame [pdf] Installation Guide Master 5 V2 Frame, 5 V2 Frame, V2 Frame, Frame

References

• User Manual