Installation Guide for Speedy Bee models including: Master 5 V2 Frame, 5 V2 Frame, V2 Frame, Frame
download
SpeedyBee Master 5 HD 5″ Freestyle Frame - KiwiQuads
* (Note: 3D eect requirements, the actual object shall prevail) CNC camera mount and camera side plate installation M3*5 Front top plate Install the front top plate M2*3 Camera side plate 2 Antenna Installation Sequence 1 inse the O-ring into the antenna to secure it on the TPU antenna base. Install the multi-function antenna base Choose a suitable VTX antenna base SMA antenna base (*Note: pictures for assembly reference only. Frame doesn't include antenna) 1 Install the plate on one side and GPS base M2.5*8 Choose a suitable VTX antenna base 2 Install the T-shaped antenna M3*23 stando O3 Air Unit antenna base M2.5*8 Button head hex socket screw GPS installation base (Size:18*18*8mm) Install the plate on the other side *Notice: front and back arms Install arms and anti-vibration module (Complete the installation of 4 arms in turn) Front arm 1 Screws pass through the bottom plate and the intersection position of the arms in turn 3 Install the anti-vibration stack module to the corresponding position Direction for drone head Back arm Back arm M3*14 2 Install the screws on both sides in the same way M3*11 M3*14 Front arm 4 Install 4 arms in the same way Install middle plate 1 Install the middle plate to the corresponding 6 screw positions Place for capacitor and buzzer bottom plate M2*8 middle plate 2 Tighten the two press-in nuts where the arms intersect Combination with completed pas 1 and 2 1 Combination of frame and CNC camera mount 2 Install 7075 stando M3*5 3 Bottom protection silicone (0.5mm) M2.5*6 M3*6 4 Frame and antenna base combination Install rear top plate and batte anti-slip silicone M3*6 Rear top plate Stack protector M2*4 1 Finally, install the rear top plate and batte anti-slip silicone Batte anti-slip silicone (2.5mm) M3*6 M3*6 *Notice: please change to M3*6 button head hex socket screws if installing TPU protection at the drone head pa. Arm foot mount installation 1 Install the 3D printed foot mount to arms 2 Use screw of proper length based on the motor installation 5mm M3*8 M3*10 (*Notice: default screws are M3*8mm, M3*10mm) O3 Air Unit Installation Method O3 Air Unit VTX Pass through the top of the VTX O3 Air Unit 6P ex cable Master honeycomb heat sink M1.6*8 The 4 original screws at the bottom of the O3 Air Unit need to be removed Recommend installing ESC in reverse horizontally 180° *Note (After the ESC is installed reversely, remember to redene the correct position and direction of motors 1-4.) It is recommended to keep the power cable of ESC to be about 100mm. Please refer to the used batte for actual length. Suggesting place for main power cable ESC power cable soldering and recommended length for cable of motor *Note: connect buzzer with mark to BZ+ of ight controller, and buzzer without mark to BZ- Capacitor Buzzer Inner motor wire recommended length: 110mm Outer motor wire recommended length: 93mm 93mm ESC ESC 11 Scale 0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 Scan the QR code to get the installation guide. We recommend you scan it through the SpeedyBee App for detailed instructions. SpeedyBee APP Installation Guidance Facebook QR CodeAdobe Illustrator 25.4 (Windows) GPL Ghostscript 10.01.2